Sectioning and Partial Part Replacement: 2017 RAM 1500

Submit a new collision repair question here!

Sectioning and Partial Part Replacement: 2017 RAM 1500

One of the top technical inquiries received at Ask I-CAR is “Is there a sectioning or partial replacement procedure available?” To help answer this question, RTS has an OEM Partial Part Replacement Search. Here you will find information on if these procedures are available on a specific vehicle. Let’s take a closer look at the 2017 RAM 1500.

The full OEM Part Replacement Search for the 2017 RAM 1500 can be viewed on I-CAR’s website. This will give you a good understanding on general areas for sectioning or partial replacement. I-CAR does not have permission to show exact locations for sectioning or the procedure itself. However, Fiat Chrysler Automobiles (FCA) has both a free and paid subscription website with collision repair information.

The RAM has a single sectioning location for the front lower rails. This procedure allows for replacement of the front portion of the of the rail. It is reattached with an open-butt joint. A single location for sectioning is available for the upper rail. To attach, a two-inch backer is created for the section joint. The rear rails do not have replacement procedures available.

The outer uniside can be sectioned in multiple locations. FCA’s recommended repair includes using a butt-joint with a backer. The sectioning joint can be made using either welding or adhesives. The uniside reinforcements have multiple areas that may be sectioned. The sectioning joint used is a combination of a lap joint and a butt joint. The RAM body repair manual states, “Service assemblies for body components may be disassembled if utilization of the subcomponents is more appropriate to the repair or to reduce vehicle disruption.”

For additional FCA information, check out the following pages:
Chrysler OEM Information
Dodge OEM Information
Fiat OEM Information
Jeep OEM Information
RAM OEM Information

Additional I-CAR Collision Repair News you may find helpful:
Collision Information Website Access: Fiat Chrysler Automobiles
Step-By-Step: Accessing Fiat Chrysler Automobile Repair Information
What's A RAM Shotgun?

Related I-CAR Courses

MIG Brazing What Is It, Why Should I Use It? June 02, 2014
Why MIG Brazing? It is widely known that GMA (MIG) welded; fully galvanized steel will lose some of its properties, including corrosion protection, due to the heat created during welding.…
2015 Ford F-150 Outer Box Side Replacement Options August 07, 2015
The method for replacing the outer box side on the 2015 Ford F-150 has been a popular area of discussion, and many people are asking, "What are my options and…
I-CAR Best Practice: Recycled Outer Quarter Panels w/Rolled Hem Flanges July 21, 2017
Periodically, I-CAR Repairability Summits are held to bring together collision industry stakeholders and subject matter experts to develop collision repair processes and best practices for repair of late-model, collision damaged…
Restraints Wiring Repairs May 23, 2016
Over the past few months, we've been sharing OEM position statements on restraints wiring repairs. Now we're bringing them all together in one place for easy reference.
Mazda I-ELOOP Overview January 27, 2014
Beginning model year 2014, Mazda has introduced a regenerative engine braking system called i-ELOOP, short for "Intelligent Energy Loop." In this system, a capacitor is used to store electrical energy…
Typical Calibration Requirements for Blind Spot Sensors October 19, 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system…
Toyota/Lexus/Scion Position Statement: Pre- and Post-Repair System Scanning July 28, 2016
As the industry continues to ask, are pre- and post-repair scans necessary, Toyota/Lexus/Scion provides their answer.
2012 Ford Focus Active Grille Shutters January 01, 2014
When making collision repairs to the 2012 Ford Focus, be aware that the vehicle may be equipped with an active grille shutter system (see Figure 1). This motorized system is…
Fiat Chrysler Automobiles (FCA) Position Statement: Pre- and Post-Repair System Scanning June 09, 2016
Fiat Chrysler Automobiles US LLC has released a position statement related to the use of scan tools following collisions. In the position statement, FCA states:
Typical Calibration Requirements for Park Assist Sensors October 31, 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system…

Sectioning and Partial Part Replacement: 2018 Volvo S60 January 18, 2019
One of the top technical inquiries received at Ask I-CAR is, “Is there a sectioning or partial replacement procedure available?” To help answer this question, RTS has an OEM Partial…
Nissan/INFINITI: Single-Use Parts Replacement Position Statement January 14, 2019
It is often asked, can this fastener, clip, or part be reused? How can we tell if it can or cannot be reused?
Nissan/INFINITI Position Statements Available - UPDATE January 14, 2019
There's a new addition to the OEM Information page for Nissan/INFINITI. Nine new and revised position statements have been released fore each manufacturer that are now available for viewing on…
Nissan/INFINITI Position Statement: Pre- and Post-Repair Scanning - UPDATE January 14, 2019
Nissan/INFINITI updated their position statement on pre- and post-repair scanning. The revised position statement touches on more subjects and gives additional information on the subject.
ADAS, Calibration, and Scanning Article Hotspot January 14, 2019
Since advanced driver assistance systems (ADAS), scanning, and calibration first started becoming relevant, members of the collision repair industry have required as much knowledge as possible on these subjects. I-CAR’s…
Survey: Refinishing Materials January 10, 2019
To assist I-CAR in meeting each individual’s needs, we have issued a survey to gather information that will aid in new course development. This short survey is intended to gather…
Your 2018 Favorites: Top Ten Vehicles in OEM Calibration Requirements Search January 10, 2019
Now that the new year is underway, let’s take a look at some of your favorite things from 2018. We will continue with your most visited vehicles in the OEM…
Pre- and Post-Repair System Scanning Position Statements January 09, 2019
Are you wondering if a particular OEM or organization has a published position statement on pre-repair and post-repair scanning? We have compiled a list of most of the position statements…
Your 2018 Favorites: Top Ten Sectioning and Partial Part Articles January 08, 2019
Now that the new year is underway, let’s take a look at some of your favorite things from 2018. We will continue with your favorite sectioning and partial part replacement…
Jaguar Land Rover Position Statements Available January 07, 2019
There's a new addition to the OEM Information page for Jaguar Land Rover. An icon has been added that will link you to a page containing collision repair position statements.

2019
- January 2019 (13)

2018
- December 2018 (18)
- November 2018 (20)
- October 2018 (17)
- September 2018 (16)
- August 2018 (23)
- July 2018 (21)
- June 2018 (22)
- May 2018 (22)
- April 2018 (20)
- March 2018 (23)
- February 2018 (20)
- January 2018 (21)

2017
- December 2017 (16)
- November 2017 (19)
- October 2017 (19)
- September 2017 (21)
- August 2017 (21)
- July 2017 (19)
- June 2017 (23)
- May 2017 (22)
- April 2017 (18)
- March 2017 (20)
- February 2017 (12)
- January 2017 (13)

2016
- December 2016 (10)
- November 2016 (13)
- October 2016 (21)
- September 2016 (13)
- August 2016 (12)
- July 2016 (10)
- June 2016 (13)
- May 2016 (12)
- April 2016 (12)
- March 2016 (14)
- February 2016 (12)
- January 2016 (9)

2015
- December 2015 (11)
- November 2015 (10)
- October 2015 (13)
- September 2015 (11)
- August 2015 (13)
- July 2015 (13)
- June 2015 (13)
- May 2015 (12)
- April 2015 (15)
- March 2015 (15)
- February 2015 (11)
- January 2015 (13)

2014
- December 2014 (15)
- November 2014 (9)
- October 2014 (13)
- September 2014 (11)
- August 2014 (13)
- July 2014 (15)
- June 2014 (12)
- May 2014 (14)
- April 2014 (11)
- March 2014 (6)
- February 2014 (1)
- January 2014 (28)

Hyundai	Does Hyundai have a sectioning procedure available?
2013 Ford F-Series Pickup	Is there a sectioning procedure available for the front frame horn?
2013 Honda Accord	Is there a sectioning procedure available for the B-pillar reinforcement?
Kia	Does Kia have a sectioning procedure available?
2013 Honda Accord	Is there a sectioning procedure available for the front lower rails?
2014 Toyota Tundra	Is there a sectioning procedure available for the front lower rails?
2013 Ford Taurus	Is there a sectioning procedure available for the front lower rails?
2011 RAM Ram	Is there a sectioning procedure available for the front lower rails?
2014 Volkswagen Jetta	Is there a sectioning procedure available for the front lower rails?
2012 Chrysler 300	Is there a sectioning procedure available for the front lower rails?

Educational Programs

I-CAR offers a variety of educational and training recognition programs for the collision repair industry.

PROGRAMS

RECOGNITION

Technical Knowledge

Repairability Technical Support Portal

Solutions

Need a solution related to collision repair or training program development? I-CAR can help.

Sectioning and Partial Part Replacement: 2017 RAM 1500

Related I-CAR Courses

Top Ten Vehicle Specific Questions

Top Ten I-CAR Specific Questions

I-CAR Tech Center (RTS)