For 2019, the MAZDA6 has standard collision warning, collision braking, blind spot detection, rear cross traffic, lane keep assist, lane departure warning, adaptive cruise control, and rear view systems. Optional systems include park assist, and 360° camera view, Traffic Sign Recognition, and Adaptive Lighting. This means that there is a large array of cameras and sensors that collision repairers will need to be aware of, many of which will require calibrations. Information for when these calibrations are required can be found in the vehicle specific repair information, and also on the 2019 MAZDA6 OEM Calibration Requirements Search page.

Located in the front bumper cover, there are four ultrasonic sensors. There are an additional four ultrasonic sensors located in the rear bumper. These sensors are used by the park assist system. These sensors do not require calibration. Behind the Mazda emblem, in the grille, is a radar sensor. This sensor sends information to the collision warning and collision braking systems, as well as the adaptive cruise control system. Calibration will be required for this sensor after certain events. This is a static calibration.

Located near the Mazda emblem in the grille, is the front camera that is part of the 360° camera view system. This four-camera system also has cameras located on the bottom of each exterior side mirror. A final camera is located near the center of the deck lid beneath the Mazda emblem. This camera is also part of the rear view system. There are several events that will make calibration necessary for these cameras. The calibration procedure for these cameras is static.

In front of the rearview mirror, attached to the windshield, is a forward-facing camera. This camera sends data to the lane departure warning and lane keep assist systems. It also provides input to the collision warning, collision braking, adaptive lighting, and traffic sign recognition systems. There are several events that make calibration necessary for this camera. There are both static and dynamic calibration procedures for this camera.

Located behind the rear bumper cover, there is a radar sensor on each corner of the vehicle. The sensors are mounted to the lower quarter panel. These sensors are used by the blind spot detection and rear cross traffic systems. There are several events that will require a calibration. This is a static calibration.

This is just a brief overview of some of the different required procedures for the 2019 MAZDA6. Always consult the OEM repair information to get the exact information and procedures required to service the ADAS.

For additional Mazda information, check out the Mazda OEM Information page.

Additional I-CAR Collision Repair News you may find helpful:
ADAS, Calibration, And Scanning Article Hotspot
Collision Information Website Access: Mazda
How To Use The OEM Calibration Requirements Search
Locating ADAS Information: Mazda

Related I-CAR Courses

Course I-CAR ADAS Courses