Close
MENU

Follow us on @Ask_ICAR for daily updates.

Home / Collision Repair News / OEM Linking Pin: Honda/Acura Weld-On Attachments - UPDATE

OEM Linking Pin: Honda/Acura Weld-On Attachments - UPDATE

Posted on 19 January 2022 | Share: | Print Print

You’ve been asking us if Honda/Acura allows weld-on attachments (pins, washers, tabs, etc.) on outer body panels for dent repair. Through our I-CAR linking pin activity, we reached out to Honda/Acura for the answer. Let’s take a look at their response.

Per our contact at Honda/Acura: "The use of weld-on pins, washers, and tabs for pulling is allowed up to 590 MPa steels. Currently our outer body panels are 340 and 270. In the future, the possibility exists for these panels to be made of higher strength steels. The body repair manual should always be referenced prior to using weld-on pulling equipment to determine strength of the panels. Corrosion protection must be addressed on both sides of the panel after repairs are made."

How does this relate to the Honda/Acura Steel Repairability Matrix? We once again reached out for clarification.

Per our contact at Honda/Acura: "When welding a stud, washer, or other attachment used in panel straightening, there is a minimal amount of heat generated; that heat is limited to the contact point of the attachment. This isolates the amount of heat that is put into that panel overall. This isolation is what allows the panel to be straightened using these methods. The heating guidelines referenced in the Honda/Acura Steel Repairability Matrix are for a larger area for structural straightening, heat shrinking, and other straightening methods that use heat over a larger area."

Additional information on using weld-on attachments can be found at www.techinfo.honda.com in the Honda/Acura vehicle-specific body repair manual under Body Repair Basic ➤ Repairing Minor Body Damage - Washer Welding Repair

For additional Honda/Acura information, check out the following pages:
Honda OEM Information
Acura OEM Information

Additional I-CAR Collision Repair News you may find helpful:
How Does the I-CAR OEM Linking Pin Process Work?
Straightening And Heat: Honda/Acura
Where Do I Find Other Types Of Information In Honda/Acura?

Related I-CAR Courses

Course Steel Dent Pulling

Top Ten Vehicle Specific Questions

Hyundai Does Hyundai have a sectioning procedure available?
Kia Does Kia have a sectioning procedure available?
Chevrolet Does Chevrolet have a warning against sectioning when there is no procedure?
BMW Can I-CAR send me BMW repair procedures?
Honda What does Honda say about repairing damaged airbag system wiring harnesses?
Hyundai Does Hyundai have part replacement procedures available?
Mercedes-Benz Can I-CAR send me Mercedes-Benz repair procedures?
Honda What does Honda say about straightening front lower rails?
Subaru Do you have to replace a front passenger airbag on a Subaru even if the airbag did not deploy? The repair information seems to indicate that it should.
Nissan Is there a wiring repair procedure for the airbag connector?

Top Ten I-CAR Specific Questions

What does I-CAR say about using a recycled quarter panel assembly that includes the inner, outer, and reinforcements?
What does I-CAR say about straightening a kink?
Can I-CAR General Sectioning Guidelines be used?
What does I-CAR say about repairing damaged door intrusion beams?
What does I-CAR say about the decision to use recycled parts?
What does I-CAR say about replacing suspension parts in pairs?
What does I-CAR say about repairing damaged bumper reinforcements?
What does I-CAR say about repair tolerances?
What does I-CAR say about using recycled airbags?
What does I-CAR say about repairing damaged crush boxes?