Ultra-high-strength steel (UHSS) is a common construction material on vehicles. When replacing components, test welds should be made on similar materials before every welding repair. How do you test-weld UHSS? What do you look for?
Typically, test welds and tuning the welder include performing a destructive test. This verifies the quality of the welds being made on the replacement parts.
When making test welds in preparation for installing a UHSS part, things are a little different. Due to the high strength of the steel, the part material is harder and stronger than the weld produced. Therefore, the tearout you usually look for during mild steel destructive testing is almost impossible to produce.
While performing GMA test welds, look for:
- Any indent made in the base material during the destructive test.
- Tearout of the top panel, especially when welding thin panels to thick UHSS.
- The heat-affect zone.
- The appearance of a ripple on the backside of the weld.
Some vehicle makers have specific requirements for GMA welds, such as:
- Weld size
- Specific welding wire
- Specific shielding gas
Many vehicle makers have specific requirements for squeeze-type resistance spot welds (STRSW) performed on UHSS. These requirements can be found in the vehicle-specific body repair manual, or inline within the specific procedure.
To learn more about vehicle maker welding recommendations, please reference the Steel Spot And Plug Weld Nugget Size: UPDATE article.
Knowing the construction materials and welding conditions for replacement parts is crucial knowledge to perform a quality, safe repair.
Additional I-CAR Collision Repair News you may find helpful:
- Back-To-Basics: Destructive Weld Testing
- Back-To-Basics: Weld Inspection During The Repair Process
- Welding And MIG Brazing Hotspot
- Working With Boron-Alloyed Steel

Print