I-CAR RTS Collision Repair Technical Bulletins

FCA/Stellantis Position Statement: Steering System

Posted on 01 April 2021

FCA/Stellantis released a position statement related to steering system inspection and part replacement after a collision.

Kia: Who Requires Or Recommends MIG Brazing?

Posted on 30 March 2021

In Europe, MIG brazing has been required or recommended on a widespread basis for several years. In the U.S., MIG brazing is not as common but is becoming more prevalent. As the RTS team is researching MIG brazing information, we are putting together a series of articles that identify OEM-specific MIG brazing recommendations and requirements for vehicles in the U.S. Let’s see what Kia has to say.

I-CAR Introduction To Electric Vehicle (EV) Service Considerations Course

Posted on 29 March 2021

I-CAR is currently developing numerous electric vehicle (EV) courses. These courses detail different aspects of high-voltage (HV) vehicles and provide practical information on how to safely move, store, inspect, and repair EVs.

Repairer Driven News: BMW Reminder To Check OEM Procedures

Posted on 26 March 2021

Repairer Driven News (RDN) released an article on BMW vehicles and the importance of checking and following OEM procedures.

I-CAR Collision Reporter - The Electrification Issue

Posted on 25 March 2021

The fifteenth installment of the I-CAR Collision Reporter - The Electrification Issue has been released. This issue focuses on electric vehicles (EVs) and how they are here to stay a part of the industry.

Non-SRS Wiring Repairs: Volkswagen

Posted on 24 March 2021

What is a non-SRS wiring repair? It is the repairing of an electrical component that is not part of the supplemental restraints system circuit (usually identified by yellow wire looms). As technology increases on vehicles, so does the number of components that utilize electricity. Many of the sensors and modules are becoming smarter and more sensitive. If the wire is too long, the wrong gauge, or spliced in the wrong location it can cause malfunctions in the components that it’s powering. Many OEMs have different restrictions and guidelines for repairing wiring that does not control SRS components. On the other hand, there are OEMs that don’t allow wiring repairs at all, so full harness replacement is the only option.

Non-SRS Wiring Repairs: Audi

Posted on 24 March 2021

Steel Spot And Plug Weld Nugget Size: Subaru - UPDATE

Posted on 23 March 2021

Did you know that some OEMs specify nugget size for spot and plug welds? This information is typically found within vehicle-specific repair procedures or can be found under general welding guidelines. Let’s see what Subaru has to say.

I-CAR Electric Vehicle (EV) Damage Analysis Course

Posted on 18 March 2021

Volkswagen: Who Requires Or Recommends MIG Brazing?

Posted on 17 March 2021

Audi: Who Requires Or Recommends MIG Brazing?

Posted on 17 March 2021

Honda/Acura ADAS Information Documents: UPDATE

Posted on 16 March 2021

Honda/Acura has released updated versions of their advanced driver assistance systems (ADAS) related Job Aids.

Toyota/Lexus/Scion Position Statement: Pre- and Post-Repair System Scanning Thursday, 28 July 2016
As the industry continues to ask if pre- and post-repair system scanning is necessary, Toyota/Lexus/Scion provides their answer.
Pre- and Post-Repair System Scanning Statements Wednesday, 9 January 2019
Are you wondering if a particular OEM or organization has a published statement on pre-repair and post-repair scanning? We have compiled a list of most of the statements on the subject, so you can...
ADAS, Calibration, And Scanning Article Hotspot Monday, 14 January 2019
Since advanced driver assistance systems (ADAS), scanning, and calibration first started becoming relevant, members of the collision repair industry have required as much knowledge as possible on...
BMW Position Statement: Pre- and Post-Repair System Scanning - UPDATE Friday, 10 April 2020
BMW has released a position statement related to pre- and post-repair system scanning. The statement applies to All vehicles equipped with on board diagnostics II (OBD II).
Honda/Acura Position Statement: Pre- and Post-Repair System Scanning - UPDATE Wednesday, 22 May 2019
Honda /Acura has updated their position statement on pre- and post-repair scanning to give more clarification on what is expected for scanning.
Quickly Identifying Outer Quarter Panels w/Rolled Hem Flanges Monday, 5 March 2018
The I-CAR best practice article, Recycled Outer Quarter Panels w/Rolled Hem Flanges has gotten a lot of interest from the collision repair industry. It’s important to know which vehicles are...
General Motors Position Statement: Pre- and Post-Repair System Scanning Friday, 21 October 2016
As the industry continues to ask, are pre- and post-repair scans necessary, General Motors provides their answer.
Restraints Wiring Repairs Monday, 23 May 2016
Over the past few months, we've been sharing OEM position statements on restraints wiring repairs. Now we're bringing them all together in one place for easy reference.
FCA/Stellantis Position Statement: Pre- and Post-Repair System Scanning Thursday, 9 June 2016
FCA/Stellantis has released a position statement related to pre- and post-repair system scanning.
Typical Calibration Requirements For Forward Radar Sensors Wednesday, 12 October 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system to not...

Your 2025 Favorites: Top Articles Friday, 16 January 2026
As 2026 rolls in, we can reflect back on what the previous year had to offer. Let's take a look at some of the collision industry information you've been most interested in from this past year....
App-Based Connected Services Considerations: Toyota/Lexus Thursday, 15 January 2026
Have you had the experience where the vehicle notified the owner that it was being moved while it was in your repair facility? App-based connected services are available from many vehicle makers and may...
Digital Key Considerations: Toyota/Lexus Thursday, 15 January 2026
The intermingling of technology and automobiles continues, with digital key offerings from most vehicle makers. Digital keys utilize smartphone technology to expand vehicle access and owner...
Nissan/INFINITI Position Statements: Advanced Driver Assistance System Components Thursday, 8 January 2026
Nissan/INFINITI released position statements on the use of salvaged, aftermarket, and "secondary-market" advanced driver assistance systems (ADAS) components.
I-CAR Repairers Realm: RTS 2025 Year In Review - Now Available Tuesday, 6 January 2026
I-CAR had a discussion on the Repairability Technical Support (RTS) 2025 year in review.
Ford On Target 2025: Volume 4 Monday, 5 January 2026
Ford has released the fourth installment of their On Target publication for 2025.
Structural Sectioning Procedures: Ford/Lincoln - UPDATE Friday, 19 December 2025
Ask I-CAR receives many technical inquiries referring to sectioning. The collision repair industry wants to know where can you section, does the OEM have a sectioning procedure, and where can I find the...
Body Repair Manual Symbols: Hyundai Wednesday, 17 December 2025
While looking at repair procedures in a body repair manual (BRM) you may notice that symbols are used to indicate specific operations or parts to be used during the repair process. Most BRMs provide a...
Body Repair Manual Symbols: Genesis Wednesday, 17 December 2025
While looking at repair procedures in a body repair manual (BRM) you may notice that symbols are used to indicate specific operations or parts to be used during the repair process. Most BRMs provide a...
App-Based Connected Services Considerations: BMW Wednesday, 10 December 2025
Have you had an experience where the vehicle notified the owner that it was being moved while it was in your repair facility? App-based connected services are available from many vehicle makers and...