Mercedes-Benz Position Statement: Steering Components

Submit a new collision repair question here!

Mercedes-Benz Position Statement: Steering Components

The steering system on a vehicle could be considered one of the most important and necessary systems on a vehicle. After all, without steering the driver couldn’t control the vehicle. This makes it important to know what the OEM recommends when it comes to this system. Let’s take a look at what MBUSA has to say.

The MBUSA Steering Components position statement provide guidelines for when to replace steering components during a repair. The information is important to be aware of as MBUSA states that some steering parts that are damaged, may not be externally visible.

Per the MBUSA Position Statement re: Steering Components:

“the steering gear must be replaced if components of the front axle or steering gear, or any part of the steering linkage, are deformed or damaged.”
It is not possible to test a steering gear for damage in the shop.
“the steering gear is to be replaced in cases of doubt”
If the engine compartment paneling or steering plate is damaged the steering gear must be inspected for damage.
If the steering-wheel airbag is deployed the steering wheel and steering column tube must be replaced.

For additional Mercedes-Benz information, check out the Mercedes-Benz OEM Information page.

Related I-CAR Courses

Pre- and Post-Repair System Scanning Position Statements Wednesday, 09 January 2019
Are you wondering if a particular OEM or organization has a published position statement on pre-repair and post-repair scanning? We have compiled a list of most of the position statements…
Toyota/Lexus/Scion Position Statement: Pre- and Post-Repair System Scanning Thursday, 28 July 2016
As the industry continues to ask if pre- and post-repair system scanning is necessary, Toyota/Lexus/Scion provides their answer.
ADAS, Calibration, And Scanning Article Hotspot Monday, 14 January 2019
Since advanced driver assistance systems (ADAS), scanning, and calibration first started becoming relevant, members of the collision repair industry have required as much knowledge as possible on these subjects. I-CAR’s…
Typical Calibration Requirements For Blind Spot Sensors Wednesday, 19 October 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system…
Restraints Wiring Repairs Monday, 23 May 2016
Over the past few months, we've been sharing OEM position statements on restraints wiring repairs. Now we're bringing them all together in one place for easy reference.
Typical Calibration Requirements For Forward Radar Sensors Wednesday, 12 October 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system…
MIG Brazing What Is It, Why Should I Use It? Monday, 02 June 2014
Why MIG Brazing? It is widely known that GMA welded; fully galvanized steel will lose some of its properties, including corrosion protection, due to the heat created during welding. OEMs…
Honda/Acura Position Statement: Pre- and Post-Repair System Scanning - UPDATE Wednesday, 22 May 2019
Honda /Acura have updated their position statement on pre- and post-repair scanning to give more clarification on what is expected for scanning.
Typical Calibration Requirements For Park Assist Sensors Monday, 31 October 2016
Technicians should be aware of what’s required to keep advanced driver assistance systems (ADAS) running safely after a collision. Whether that be aiming a camera, which can cause a system…
Mazda I-ELOOP Overview Monday, 27 January 2014
Beginning model year 2014, Mazda has introduced a regenerative engine braking system called i-ELOOP, short for "Intelligent Energy Loop." In this system, a capacitor is used to store electrical energy…

GM Repair Insights: Spring 2023 Tuesday, 28 March 2023
The spring 2023 edition of General Motors (GM) Repair Insights magazine is now available.
Back-To-Basics: Considerations For Choosing The Right Spraybooth Friday, 24 March 2023
Sometimes going back-to-basics can make the difference between a quality repair and a failed repair. When it comes to choosing the right spraybooth, there are a few considerations.
Hyundai/Genesis Releases Additional Body Repair Manuals: UPDATE Wednesday, 22 March 2023
Hyundai Motor America has updated their approved body repair manuals (BRMs) available to the United States market. This also includes the new addition of Genesis branded BRMs!
I-CAR Repairers Realm: Spray Gun Operation and Maintenance - Coming Soon Tuesday, 21 March 2023
I-CAR is having a discussion on spray gun operation and maintenance. Tune into Repairers Realm to listen and join in for questions and answers.
OEM Emergency Response Guides: Jaguar Land Rover Friday, 17 March 2023
Are you looking for OEM emergency response guides (ERGs)? The Repairability Technical Support (RTS) team has located these guides and either houses them on the RTS website, provides links to…
Corrosion Protection Guidelines: Maserati Thursday, 16 March 2023
A key factor in collision repair is making long-lasting repairs. When a vehicle is repaired, many areas of corrosion protection are disturbed. This creates corrosion hot spots, that left untreated…
I-CAR Repairers Realm: Paint Booth And Fresh Air Filtration System Overview - Now Available Tuesday, 14 March 2023
I-CAR had a discussion on paint booth fresh air filtration systems.
Honda Has Released the 2023 HR-V Model Body Repair News Wednesday, 08 March 2023
Honda has released a Body Repair News bulletin for the 2023 Honda HR-V. This document provides relevant repair information at a glance for this redesigned vehicle.
Acura Has Released The 2023 Integra Body Repair News Wednesday, 08 March 2023
Acura has released a Body Repair News bulletin for the 2023 Acura Integra. This document provides relevant repair information at a glance for this new vehicle.
Locating OEM-Approved HV Tools: Mercedes-Benz Tuesday, 07 March 2023
When researching procedures for disabling a high-voltage (HV) vehicle, you may notice that many of the procedures require the use of specific tools. Some of them are OEM-specific tools or…

2023
- March 2023 (13)
- February 2023 (10)
- January 2023 (11)

2022
- December 2022 (11)
- November 2022 (12)
- October 2022 (11)
- September 2022 (13)
- August 2022 (12)
- July 2022 (11)
- June 2022 (13)
- May 2022 (11)
- April 2022 (12)
- March 2022 (12)
- February 2022 (12)
- January 2022 (13)

2021
- December 2021 (15)
- November 2021 (12)
- October 2021 (13)
- September 2021 (15)
- August 2021 (12)
- July 2021 (16)
- June 2021 (17)
- May 2021 (14)
- April 2021 (15)
- March 2021 (21)
- February 2021 (15)
- January 2021 (14)

2020
- December 2020 (14)
- November 2020 (17)
- October 2020 (12)
- September 2020 (14)
- August 2020 (12)
- July 2020 (18)
- June 2020 (16)
- May 2020 (14)
- April 2020 (20)
- March 2020 (12)
- February 2020 (14)
- January 2020 (14)

2019
- December 2019 (13)
- November 2019 (19)
- October 2019 (25)
- September 2019 (20)
- August 2019 (22)
- July 2019 (23)
- June 2019 (21)
- May 2019 (19)
- April 2019 (21)
- March 2019 (21)
- February 2019 (21)
- January 2019 (18)

2018
- December 2018 (19)
- November 2018 (19)
- October 2018 (17)
- September 2018 (16)
- August 2018 (22)
- July 2018 (21)
- June 2018 (21)
- May 2018 (19)
- April 2018 (19)
- March 2018 (22)
- February 2018 (17)
- January 2018 (20)

2017
- December 2017 (15)
- November 2017 (15)
- October 2017 (19)
- September 2017 (20)
- August 2017 (21)
- July 2017 (18)
- June 2017 (23)
- May 2017 (20)
- April 2017 (15)
- March 2017 (18)
- February 2017 (11)
- January 2017 (13)

2016
- December 2016 (9)
- November 2016 (14)
- October 2016 (21)
- September 2016 (11)
- August 2016 (11)
- July 2016 (8)
- June 2016 (13)
- May 2016 (11)
- April 2016 (11)
- March 2016 (13)
- February 2016 (11)
- January 2016 (9)

2015
- December 2015 (10)
- November 2015 (8)
- October 2015 (10)
- September 2015 (7)
- August 2015 (11)
- July 2015 (10)
- June 2015 (8)
- May 2015 (8)
- April 2015 (9)
- March 2015 (8)
- February 2015 (9)
- January 2015 (11)

2014
- December 2014 (12)
- November 2014 (7)
- October 2014 (12)
- September 2014 (10)
- August 2014 (9)
- July 2014 (12)
- June 2014 (9)
- May 2014 (14)
- April 2014 (9)
- March 2014 (6)
- February 2014 (1)
- January 2014 (27)

Hyundai	Does Hyundai have a sectioning procedure available?
Kia	Does Kia have a sectioning procedure available?
Chevrolet	Does Chevrolet have a warning against sectioning when there is no procedure?
BMW	Can I-CAR send me BMW repair procedures?
Honda	What does Honda say about repairing damaged airbag system wiring harnesses?
Hyundai	Does Hyundai have part replacement procedures available?
Mercedes-Benz	Can I-CAR send me Mercedes-Benz repair procedures?
Honda	What does Honda say about straightening front lower rails?
Subaru	Do you have to replace a front passenger airbag on a Subaru even if the airbag did not deploy? The repair information seems to indicate that it should.
Nissan	Is there a wiring repair procedure for the airbag connector?

	What does I-CAR say about using a recycled quarter panel assembly that includes the inner, outer, and reinforcements?
	What does I-CAR say about straightening a kink?
	Can I-CAR General Sectioning Guidelines be used?
	What does I-CAR say about repairing damaged door intrusion beams?
	What does I-CAR say about the decision to use recycled parts?
	What does I-CAR say about replacing suspension parts in pairs?
	What does I-CAR say about repairing damaged bumper reinforcements?
	What does I-CAR say about repair tolerances?
	What does I-CAR say about using recycled airbags?
	What does I-CAR say about repairing damaged crush boxes?

Mercedes-Benz Position Statement: Steering Components

Related I-CAR Courses

Top Ten Vehicle Specific Questions

Top Ten I-CAR Specific Questions