Close
MENU

Follow us on @Ask_ICAR for daily updates.

Home / Collision Repair News / Back-To-Basics: Masking vs. Removing

Back-To-Basics: Masking vs. Removing

Posted on 03 May 2019 | Share: | Print Print

Sometimes going back-to-basics can make the difference between a quality repair and a failed repair. When it comes to refinishing, there are a few guidelines to remember when making a decision to either mask or remove a part.

The decision to remove or mask a part can come from a few things. Part location and access, whether a part has one-time use hardware, as well as the ability to prep a panel, and protect it from overspray. For example, if an entire door panel is being refinished, it would be difficult to thoroughly sand and clean a door panel if the handle and molding were still attached. It also might be difficult to properly mask these parts to protect them from overspray. The finish of these parts may also be damaged by, or the removal of overspray. In this case, removing the door handle and molding would be the best option.

On the other hand, some moldings on vehicles require a new molding when one is removed, as well as one-time use fasteners. There may also be parts on a vehicle that have no direct access to the backside to remove the part, or the steps to remove the part are extensive, making masking the more efficient option. Another example for masking would be if a door panel was only being blended.

The decision to remove or mask parts during the refinishing process can greatly affect the outcome and quality of the repair.

Related I-CAR Courses

Course Masking

Course Trim Removal and Installation

Top Ten Vehicle Specific Questions

Hyundai Does Hyundai have a sectioning procedure available?
Kia Does Kia have a sectioning procedure available?
Chevrolet Does Chevrolet have a warning against sectioning when there is no procedure?
BMW Can I-CAR send me BMW repair procedures?
Hyundai Does Hyundai have part replacement procedures available?
Honda What does Honda say about repairing damaged airbag system wiring harnesses?
Mercedes-Benz Can I-CAR send me Mercedes-Benz repair procedures?
Honda What does Honda say about straightening front lower rails?
Subaru Do you have to replace a front passenger airbag on a Subaru even if the airbag did not deploy? The repair information seems to indicate that it should.
Nissan Is there a wiring repair procedure for the airbag connector?

Top Ten I-CAR Specific Questions

What does I-CAR say about using a recycled quarter panel assembly that includes the inner, outer, and reinforcements?
What does I-CAR say about straightening a kink?
Can I-CAR General Sectioning Guidelines be used?
What does I-CAR say about repairing damaged door intrusion beams?
What does I-CAR say about the decision to use recycled parts?
What does I-CAR say about replacing suspension parts in pairs?
What does I-CAR say about repairing damaged bumper reinforcements?
What does I-CAR say about repair tolerances?
What does I-CAR say about using recycled airbags?
What does I-CAR say about repairing damaged crush boxes?