OEM Restraints System Part Replacement Search


2020 Toyota Toyota 86

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.

Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired.

REV: 02/2020

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and Airbag ECU assembly. [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; AIRBAG SENSOR,QTR PANEL; MODULE, AIRBAG CONTROL]

• Horn button assembly [AIRBAG, STEERING WHEEL]
• Instrument panel passenger airbag assembly [AIRBAG, INSTRUMENT PNL]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front seat airbag assembly [AIRBAG,FRONT SEAT], If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
• When front seat airbags or curtain shield airbags have deployed as the result of a collision, be sure to replace No. 2 airbag sensor assembly. [AIRBAG SENSOR,FLOOR]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Airbag ECU assembly [MODULE,AIRBAG CONTROL]
• Front airbag sensors [AIRBAG SENSOR,FRONT]
• Side airbag sensor assemblies [AIRBAG SENSOR,FRT DOOR]
• Side No. 2 airbag sensor assemblies [AIRBAG SENSOR,QTR PANEL]
• Rear airbag sensors [AIRBAG SENSOR,QTR PANEL]
• No. 2 airbag sensor assembly [AIRBAG SENSOR,FLOOR]
• Horn button assembly [AIRBAG, STEERING WHEEL]
• Instrument panel passenger airbag assembly
• Curtain shield airbag assemblies
• Front seat airbag assemblies
• Front seat outer belt assemblies
• Replace any faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems.

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses