OEM Restraints System Part Replacement Search
2023 Mazda CX-30
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Switch the ignition to off2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power
REV: 02/2023
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
• Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG & SEAT ASSY,FRT; AIRBAG,ROOF]• Replace the SAS control module with a new one, once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes [MODULE,AIRBAG CONTROL]
• When replacing the passenger-side air bag module [AIRBAG, INSTRUMENT PNL] after the deployment, replace it together with the mid-wiring harness.
• After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG & SEAT ASSY,FRT]
• Once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRONT]
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRT DOOR]
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,QTR PANEL]
• Replace the seat belt once the load limiter operates
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Air Bag Module Inspection:• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions
Seatbelt assembles
Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions
Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.
• Perform the seat weight sensor inspection using the M-MDS
• Seat belt assemblies
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
