OEM Restraints System Part Replacement Search
2007 Lincoln Mark LT
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn all vehicle accessories OFF.2. Turn the ignition switch to OFF.
3. At the central junction box (CJB), located below the RH side of the instrument panel, remove the trim panel, the cover, and the restraints control module (RCM) fuse 19 (10A) from the CJB.
4. Turn the ignition ON and visually monitor the air bag indicator for at least 30 seconds. The air bag indicator will remain lit continuously (no flashing) if the correct RCM fuse has been removed. If the air bag indicator does not remain lit continuously, remove the correct RCM fuse before proceeding.
5. Turn the ignition OFF.
Warning! To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any front or side air bag SRS components and before servicing, replacing, adjusting, or striking components near the front or side air bag sensors or RCM, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
6. Disconnect the battery ground cable. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
7. Wait at least 1 minute.
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
• All deployed devices (driver air bag, passenger air bag, safety belt pretensioners, etc.)• Front impact sensor
• Clockspring (when the driver air bag module has deployed)
• Restraints control module (RCM) (includes sensors)
• All seat belt assemblies (pretensioners, switches, belts, buckles, and retractors), including child safety seat tether anchors and bracket assemblies, that were in use
• Any damaged or defective restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering column and wheel• Clockspring (when the driver module has deployed, the clockspring must be replaced)
• Instrument panel knee bolsters and mounting points
• Instrument panel braces and brackets
• Instrument panel and mounting points
• Restraints control module bracket and surrounding sheet metal
• Supplemental restraint system (SYS) wiring, wiring harnesses and connectors
• Impact sensor brackets and surrounding sheet metal
• Any restraint system part or wiring identified by the restraint diagnostic checks
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
