OEM Restraints System Part Replacement Search
2018 Toyota Corolla iM
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF and remove key.2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
• Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired.
• Before repairs, remove the airbag sensor assemblies if impacts are likely to be applied to the sensor during repairs
REV: 12/2017
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and the airbag sensor assembly (center airbag sensor assembly):• SHorn button assembly,[AIRBAG, STEERING WHEEL], [if deployed]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER], [if deployed]
• Instrument panel passenger airbag assembly, [AIRBAG, INSTRUMENT PNL], [if deployed]
• Curtain shield airbag assembly, [AIRBAG,ROOF], [if deployed]
• Front seat airbag assemblies, [AIRBAG,FRONT SEAT], [if deployed]
• Front seat cushion airbag assembly [AIRBAG,FRT SEAT CUSHION]
• Airbag sensor assembly center, [MODULE, AIRBAG CONTROL]
Replace all sensors in the damaged areas (anywhere in need of repair):
• [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL]
• If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
• If the front seat cushion airbag assembly RH has been deployed, replace the front seat cushion airbag assembly RH, front seat adjuster assembly RH, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Airbag ECU assembly [MODULE,AIRBAG CONTROL]• Front airbag sensors [AIRBAG SENSOR,FRONT]
• Door side airbag sensors [AIRBAG SENSOR,FRT DOOR]
• Side airbag sensor assemblies [AIRBAG SENSOR,SIDE]
• Rear airbag sensors [AIRBAG SENSOR,QTR PANEL]
• Horn button assembly [AIRBAG,STEERING WHEEL]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER]
• Instrument panel passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assemblies
• Front seat airbag assemblies
• Front seat airbag sub-assembly
• Front seat outer belt assemblies
• Replace any faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems.
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
