OEM Restraints System Part Replacement Search
2018 Acura RDX
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped)Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors
1. Press the engine start/stop button to select the OFF mode
3. Disconnect the negative cable from the battery
4. Wait at least 3 minutes before beginning work
REV: 07/2017
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a collision where the front seat belt tensioners deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FRONT]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FRONT]
• Front passenger's side A-pillar trim (deployed front passenger's airbag)
After a collision where the side airbag deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Front seat belt(s)
• Side impact sensor(s) (First) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim
• Seat frame and related parts: After a collision where the side airbag was deployed, replace the side airbag and the seat frame with the new parts. If the seat-back cover is split, it must be replaced
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,SIDE]
• Side impact sensor(s)(second) [AIRBAG SENSOR,QTR PANEL]
• A-pillar trim
• B-pillar upper trim
• Quarter pillar trim
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor
• Headliner
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, check for DTCs with the HDS for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, etc.).• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed
• Do not replace the ODS unit (USA and Canada models) unless it is physically damaged or a specific fault was found during DTC troubleshooting because it could complicate troubleshooting other DTCs
• After a vehicle collision, do the ODS unit operation check.
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel. [CLOCK SPRING]
• Seat belt assemblies
• Seats
• Check the front passenger's weight sensor output after a vehicle collision
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
