OEM Restraints System Part Replacement Search
2011 Toyota Camry
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
When troubleshooting the SRS, always inspect DTCs before disconnecting the battery.1. Turn ignition switch to OFF
2. Disconnect the negative (-) terminal cable is from the battery
3. Wait at least 90 seconds.
REV: 02/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
With a front airbag deployment:• Steering Pad, [AIRBAG,STEERING WHEEL], if deployed
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER], if deployed
• Front passenger airbag assembly, [AIRBAG,INSTRUMENT PNL], if deployed
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Front airbag sensor on the impacted side, [AIRBAG SENSOR,FENDER]
With a side airbag deployment:
• If the side airbag was deployed, replace the front seat airbag assembly [AIRBAG,FRONT SEAT]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Side airbag sensor on the impacted side, [AIRBAG SENSOR,SIDE]
With a side curtain airbag deployment:
• Curtain shield airbag assembly, [AIRBAG,ROOF], if deployed
• Center airbag sensor assembly, [MODULE,AIRBAG CONTROL]
• Side airbag sensor on the impacted side, [AIRBAG SENSOR,SIDE]
• Rear airbag sensor on the impacted side, [AIRBAG SENSOR,QTR PANEL]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
If any of these parts have been dropped, or a defect is found (e.g. cracks, dents or any other defects) in any of the housings, brackets or connectors, then replace the part with a new one:• Steering Pad (steering wheel mounted airbag)
• Front Passenger Airbag Assembly
• Driver Side Knee Airbag Assembly
• Front Seat Side Airbag Assembly
• Curtain Shield Airbag Assembly
• Center Airbag Sensor Assembly
• Front Airbag Sensor
• Front Seat Inner Belt Assembly
• Seat Position Airbag Sensor
• Occupant Classification ECU
• Side Airbag Sensor
• Rear Airbag Sensor
• Front Seat Outer Belt Assembly
Additionally inspect the:
• Steering wheel
• Instrument panel or Instrument panel reinforcement
• Front pillar garnish and Headliner
With a side airbag deployment:
• If the side airbag was deployed, inspect the, front seat frame assembly and front seat back cover, replace with the necessary parts in accordance with the extent of the collision damage.
Occupant Classification precaution:
• Perform zero point calibration and sensitivity check
• Check the flatness of the body side that is equipped with the passenger seat
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
