OEM Restraints System Part Replacement Search
2007 Ford Van
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING: Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint system (SRS) component and before servicing, removing, installing, adjusting or striking components near the front or side impact sensors or the restraints control module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats and hood latches.To deplete the backup power supply energy, disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
1.Turn all vehicle accessories OFF
2. Turn the ignition OFF
3. At the central junction box (CJB), located below the LH side of the instrument panel, remove the cover and the RCM fuse 20 (10A) from the CJB. For additional information, refer to the Wiring Diagram Manual.
4. Turn the ignition ON and monitor the air bag warning indicator for at least 30 seconds. The air bag warning indicator will remain lit continuously (no flashing) if the correct RCM fuse has been removed. If the air bag warning indicator does not remain lit continuously, remove the correct RCM fuse before proceeding.
5. Turn the ignition OFF
6. Disconnect the battery ground cable and wait at least one minute
REV: 08/2012
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any deployable device or combination of devices have deployed and/or the Restraints Control Module (RCM) has DTC B1231/B1193:00 (Event Threshold Exceeded) inmemory, the repair of the vehicle SRS is to include the removal of all deployed devices and the installation of new deployable devices, the removal and installation of new impact sensors and the removal and installation of a new RCM.
All deployed devices:
• Drivers Air Bag Module [AIRBAG,STEERING WHEEL]
• Passengers Air Bag Module [AIRBAG,INSTRUMENT PNL]
• When the driver air bag module has deployed, a new clockspring must be installed
• Restraints control module (RCM) [MODULE,AIRBAG CONTROL] and Impact sensors [AIRBAG SENSOR,FRONT]
• Deployed Driver safety belt systems (including retractors, buckles and height adjusters)
• Deployed Passenger safety belt systems (including retractors, buckles and height adjusters)
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering column and wheel• Instrument panel knee bolsters and mounting points
• Instrument panel braces and brackets
• Instrument panel and mounting points
• Supplemental restraint system (SRS) wiring, wiring harnesses and connectors
• Restraints Control Module (RCM), DTC's, bracket and surrounding sheet metal
• Impact sensor mounting points or mounting hardware
• Seats and seat mounting points
• Safety belts, safety belt buckles and safety belt retractors
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
