OEM Restraints System Part Replacement Search
2011 Mazda CX-7
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Switch the ignition to off2. Disconnect the negative battery cable
3. Wait for 1 min or more to allow the backup power supply of the SAS control module to deplete its stored power.
REV: 01/2012
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
• Driver's airbag [AIRBAG,STEERING WHEEL], [if deployed]• Passenger's Airbag [AIRBAG,INSTRUMENT PNL], [if deployed]
• Curtain Shield Airbag [AIRBAG,ROOF], [if deployed]
Side Air Bag Module Handling:
• After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts [AIRBAG & SEAT BACK ASSY]
Seat Weight Sensor Handling:
Always replace the front passenger
seat and seat weight sensor with new ones after the front or side air bags have operated (deployed) [front passenger seat sold as components; AIRBAG SNSR,ACTIVE WEIGHT]
SAS Control Module Handling:
• Once the air bags and pretensioner
seat belts have operated (deployed) due to a collision or other causes,
the SAS control module must be replaced with a new one [MODULE,AIRBAG CONTROL]
Crash Zone Sensor Handling:
• Once the air bags and pretensioner
seat belts have operated (deployed) due to a collision or other causes,
the crash zone sensor must be replaced with a new one [AIRBAG SENSOR,FRONT]
Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one [AIRBAG SENSOR,SIDE, AIRBAG SENSOR,QTR PANEL]
Pre-tensioner seat belts:
• Be sure to replace the seat belt once the load limiter operates
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Before reusing a live (undeployed) air bag module and the pre-tensioner seat belts, always use the onboard diagnostic to diagnose the air bag module and the pre-tensioner seat belts to verify that they have no malfunction.• If a problem is found in the air bag wiring harness, always replace the wiring harness with a new one
Seat Weight Sensor Handling:
• When the vehicle has been involved in a collision, perform the seat weight sensor inspection using the M MDS
• If the collision is not hard enough to cause the front or side air bags to operate (deploy), inspect the seat weight sensor and replace it if there is any malfunction.
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
