OEM Restraints System Part Replacement Search
2008 Nissan Quest
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.
1. Turn the ignition switch OFF.
2. Disconnect both battery cables.
3. Wait at least 3 minutes.
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
For front airbag deployment:• Airbag module (driver and front passenger) ( install with new fasteners)
• Crash zone sensor and bracket. (install with new fasteners)
• Seat belt pre-tensioner assemblies following frontal collision (all applicable locations: buckle, reel, lap outer) (install with new fasteners)
• Diagnosis sensor unit (install with new fasteners)
• Spiral cable and combination switch
• Instrument panel assembly
• Any damaged restraint system part
For side airbag and side curtain airbag deployment:
• Front seat back assembly (on the side on which front side air bag is activated)
• (LH or RH) Side curtain air bag module (on the side on which side curtain air bag is activated; repair the center pillar inner, etc. before installing new one if damaged)
• Front side airbag module (on the side on which the airbag module is activated)
• Diagnosis sensor unit (install with new fasteners)
• (LH or RH) side air bag (satellite) sensor (on the side on which side airbag is activated)
• Seat belt pre-tensioner assemblies (all applicable locations: buckle, reel, lap outer) (install with new fasteners)
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Steering wheel• Wiring harness (built into steering wheel), connectors and terminals
• Passenger seat cushion assembly with Occupant Detection System control unit
• Wiring harness, connectors and terminals
• All seat belt assemblies including retractors and attaching hardware
• Any restraint system part or wiring identified by diagnostic check
For a side airbag deployment:
• Seat belt pre-tensioner assemblies (buckle, reel, lap outer) (Replace if the center pillar inner has no damage)
• Center inner pillar
• Trim/headlining
• All seat belt assemblies including retractors and attaching hardware
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
