OEM Restraints System Part Replacement Search
2024 Nissan Frontier
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN dealer.
1. Turn the ignition switch off.
2. Disconnect both battery cables
3. Wait at least 3 minutes.
REV: 05/2024
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
FOR FRONTAL COLLISION When SRS has deployed in a collision:• If the driver airbag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]
• If the front passenger airbag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pretensioners• have been activated: REPLACE the crash zone sensor and bracket with new fasteners [AIRBAG SENSOR,FRONT]
• If the Driver seat belt pretensioner has been activated: REPLACE seat belt pre-tensioner assembly with new fasteners; Confirm seat belt pre-tensioner activation using CONSULT only
• If the Passenger seat belt pretensioner has been activated: REPLACE seat belt pre-tensioner assembly with new fasteners; Confirm seat belt pre-tensioner activation using CONSULT only
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners. [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING]
• If the passenger front air bag has deployed: REPLACE the instrument panel assembly
FOR SIDE AND ROLLOVER COLLISION When SRS has deployed:
• If the LH side curtain air bag has deployed: REPLACE the LH side curtain air bag module [AIRBAG,ROOF]
• If the RH side curtain air bag has deployed: REPLACE the RH side curtain air bag module [AIRBAG,ROOF]
• If the front side air bag LH has deployed: REPLACE front seatback assembly LH [AIRBAG & SEAT BACK ASSY]
• If the front side air bag RH has deployed: REPLACE front seatback assembly RH [AIRBAG & SEAT BACK ASSY]
• If any of the SRS components have deployed: REPLACE the side airbag (satellite) sensor on the collision side with new fasteners. [AIRBAG SENSOR,SIDE]
• If any of the SRS components have deployed: REPLACE the door (satellite) sensor on the collision side with new fasteners [AIRBAG SENSOR,FRT DOOR]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners [MODULE,AIRBAG CONTROL]
• If the Driver seat belt pretensioner has been activated: REPLACE seat belt pre-tensioner assembly with new fasteners; Confirm seat belt pre-tensioner activation using CONSULT only
• If the Passenger seat belt pretensioner has been activated: REPLACE seat belt pre-tensioner assembly with new fasteners; Confirm seat belt pre-tensioner activation using CONSULT only
Replace any seat belt assembly (including anchor bolts) if:
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)FOR FRONTAL COLLISION : When SRS has deployed in a collision:
• Steering wheel
• Steering wheel harness, connectors and terminals
• Non-deployed airbags
• Harness and connectors
• Occupant classification system (Passenger seat)
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• Inspect all seat belt assemblies including retractors and attached hardware after any collision. NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.
• If any component of seat belt assembly is questionable, do not repair. Replace the entire seat belt assembly
FOR SIDE AND ROLLOVER COLLISION: When SRS has deployed in a collision:
• Non-deployed airbags
• Trim/headliner
• Center inner pillar on the collision side for damage (dents, cracks, deformation), repair if damaged
• Check for visible signs of damage (dents, cracks, deformation, etc.) of the interior trim on the collision side
• Inspect all seat belt assemblies including retractors and attached hardware after any collision. NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.
• If any component of seat belt assembly is questionable, do not repair. Replace the entire seat belt assembly
WARNING:
Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation is noted. Seat belt pretensioners should be replaced even if the seat belts are not in use during a frontal collision in which the air bags are deployed.
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
