OEM Restraints System Part Replacement Search
2023 Mazda MX-30EV
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Switch the ignition to off2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power
REV: 08/2023
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG,FRONT SEAT; AIRBAG,ROOF]Side Air Bag Module Handling:
• After a side air bag has operated (deployed), always replace the side air bag module and the seat back (pad, frame, trim) with new parts.
SAS Control Module Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one. [MODULE,AIRBAG CONTROL]
Crash Zone Sensor Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one. [AIRBAG SENSOR,FRONT]
Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one. [AIRBAG SENSOR,SIDE]
Pressure Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one. [AIRBAG SENSOR,FRT DOOR]
Load Limiter Retractor:
• Always replace the seat belt once the load limiter operates.
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Air Bag Module Inspection:• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions
Seatbelt assembles
Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions
Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.
If any of the following work is performed, perform the occupant classification sensor calibration using the M-MDS:
• Replacement with a new occupant classification sensor
• Replacement with new passenger-side seat parts
• Disassembly of the passenger-side seat
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
