OEM Restraints System Part Replacement Search
2021 Mazda MX-5 Miata
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before removing the air bag module or disconnecting the air bag module connector:1) Always switch the ignition off
2) Disconnect the negative battery cable
3) Wait for 1 min or more to allow the backup power supply of the SAS control module to deplete its stored power.
REV: 12/2023
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
• Driver's airbag [AIRBAG,STEERING WHEEL], [if deployed]• Passenger's Airbag [AIRBAG,INSTRUMENT PNL], [if deployed]
Side Air Bag Module Handling:
• LT side: After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG,FRONT SEAT]
Side Air Bag Module Handling:
RT Side: After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG,FRONT SEAT]
SAS Control Module Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one [MODULE,AIRBAG CONTROL]
Crash Zone Sensor Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one [AIRBAG SENSOR,FRT BMPR]
Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one [AIRBAG SENSOR,QTR PANEL]
Pressure Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one [AIRBAG SENSOR,FRT DOOR]
Always replace the seat belt once the load limiter operates
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Air Bag Module, Pre-tensioner Seat Belt, Lap re-tensioner Seat Belt Reuse:• Always use the on-board diagnostic to diagnose the air bag module, pre-tensioner seat belt or a lap pretensioner seat belt to verify that they have no malfunction.
Inspect the seatbelt system
Belt
ELR (Emergency Locking Retractor)
Load Limiter Retractor
ALR (Automatic Locking Retractor)
Air Bag Wiring Harness Repair:
• If a problem is found in the air bag wiring harness, always replace the wiring harness with a new one
Seat Weight Sensor Handling:
• When the vehicle has been involved in a collision, perform the seat weight sensor inspection using the M MDS
• If the collision is not hard enough to cause the front or side air bags to operate (deploy), inspect the seat weight sensor and replace it if there is any malfunction.
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
