OEM Restraints System Part Replacement Search


2021 Mazda MX-5 Miata

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

Before removing the air bag module or disconnecting the air bag module connector:

1) Always switch the ignition off
2) Disconnect the negative battery cable
3) Wait for 1 min or more to allow the backup power supply of the SAS control module to deplete its stored power.

REV: 04/2021

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

• Driver's airbag [AIRBAG,STEERING WHEEL], [if deployed]
• Passenger's Airbag [AIRBAG,INSTRUMENT PNL], [if deployed]

Side Air Bag Module Handling:
• LT side: After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG,FRONT SEAT]

Side Air Bag Module Handling:
RT Side: After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG,FRONT SEAT]

SAS Control Module Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one [MODULE,AIRBAG CONTROL]

Crash Zone Sensor Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one [AIRBAG SENSOR,FRT BMPR]

Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one [AIRBAG SENSOR,QTR PANEL]

Pressure Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one [AIRBAG SENSOR,FRT DOOR]

Always replace the seat belt once the load limiter operates

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Air Bag Module, Pre-tensioner Seat Belt, Lap re-tensioner Seat Belt Reuse:
• Always use the on-board diagnostic to diagnose the air bag module, pre-tensioner seat belt or a lap pretensioner seat belt to verify that they have no malfunction.

Inspect the seatbelt system
Belt
ELR (Emergency Locking Retractor)
Load Limiter Retractor
ALR (Automatic Locking Retractor)

Air Bag Wiring Harness Repair:
• If a problem is found in the air bag wiring harness, always replace the wiring harness with a new one

Seat Weight Sensor Handling:
• When the vehicle has been involved in a collision, perform the seat weight sensor inspection using the M MDS
• If the collision is not hard enough to cause the front or side air bags to operate (deploy), inspect the seat weight sensor and replace it if there is any malfunction.

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses