OEM Restraints System Part Replacement Search


2021 Mazda CX-3

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Switch the ignition to off
2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power

REV: 08/2022

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG,FRONT SEAT; AIRBAG,ROOF]

Side Air Bag Module Handling:
• After a side air bag has operated (deployed), always replace the side air bag module and the seat back (pad, frame, trim) with new parts.

SAS Control Module Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one. [MODULE,AIRBAG CONTROL]

Crash Zone Sensor Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one. [AIRBAG SENSOR,FRONT]

Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one. [AIRBAG SENSOR,SIDE]

Pressure Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one. [AIRBAG SENSOR,FRT DOOR]

Load Limiter Retractor:
• Always replace the seat belt once the load limiter operates.

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Air Bag Module Inspection:
• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions

Seatbelt assembles

Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions

Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.

If any of the following work is performed, perform the occupant classification sensor calibration using the M-MDS:
• Replacement with a new occupant classification sensor
• Replacement with new passenger-side seat parts
• Disassembly of the passenger-side seat

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses