OEM Restraints System Part Replacement Search


2021 Mazda CX-5

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Switch the ignition to off
2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power

REV: 12/2020

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

• Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG & SEAT ASSY,FRT; AIRBAG,ROOF]

• Replace the SAS control module with a new one, once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes [MODULE,AIRBAG CONTROL]

• When replacing the passenger-side air bag module [AIRBAG, INSTRUMENT PNL] after the deployment, replace it together with the mid-wiring harness.

• After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. [AIRBAG & SEAT ASSY,FRT]

• Once the air bags and pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRONT]

• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,FRT DOOR]

• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one even if the used one does not have any visible external damage or deformation [AIRBAG SENSOR,QTR PANEL]

• Replace the seat belt once the load limiter operates

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Air Bag Module Inspection:
• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions

Seatbelt assembles

Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions

Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.

• Perform the seat weight sensor inspection using the M-MDS
• Seat belt assemblies


Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses