OEM Restraints System Part Replacement Search


2020 Nissan Kicks

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.

1. Turn the ignition switch OFF.
2. Disconnect battery negative terminal
3. Wait at least 3 minutes.

Perform self-diagnosis using CONSULT and “AIR BAG” warning lamp

REV: 05/2020

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

FOR FRONTAL COLLISION : When SRS has deployed in a collision:

• If the driver airbag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]

• If the front passenger airbag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]

• If any of the front air bags or seat belt pretensioners• have been activated: REPLACE the crash zone sensor and bracket with new fasteners [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) with new fasteners• Confirm seat belt pre-tensioner activation using CONSULT only.
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners. [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING]
• If the passenger front air bag has deployed: REPLACE the instrument panel assembly. (integrated type)
• Always replace instrument panel pad following front passenger air bag deployment
• If the front seat back assembly is damaged, the front seat back assembly must be replaced.

FOR SIDE AND ROLLOVER COLLISION: When SRS has deployed:

• If the LH side curtain air bag has deployed: REPLACE the LH side curtain air bag module [AIRBAG,ROOF]
• If the RH side curtain air bag has deployed: REPLACE the RH side curtain air bag module [AIRBAG,ROOF]
• If the front LH side airbag has deployed: REPLACE front LH seatback assembly
• If the front RH side airbag has deployed: REPLACE front RH seatback assembly
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners [MODULE,AIRBAG CONTROL]
• If any of the SRS components have deployed: REPLACE the side airbag (satellite) sensor on the collision side with new fasteners. [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer) with new fasteners• Confirm seat belt pre-tensioner activation using CONSULT only.

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

FOR FRONTAL COLLISION : When SRS has deployed in a collision:

• Non-Deployed airbags
• Steering wheel
• All seat belt assemblies including retractors and attaching hardware
• Occupant classification system (Passenger seat)
• Harness and connectors
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)

FOR SIDE AND ROLLOVER COLLISION: When SRS has deployed in a collision:

• Non-Deployed airbags
• Seat (with front side air bag)
• Center inner pillar
• Trim/headliner
• Center inner pillar on the collision side for damage (dents, cracks, deformation), repair if damaged
• Check for visible signs of damage (dents, cracks, deformation, etc.) of the interior trim on the collision side
• All seat belt assemblies including retractors and attaching hardware
• Occupant classification system (Passenger seat)
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)

Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation is noted. Seat belt pretensioners should be replaced even if the seat belts are not in use during a frontal collision in which the air bags are deployed.

Replace any seat belt assembly (including anchor bolts) if:
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
• The seat belt was damaged in an accident (i.e. torn webbing, bent retractor or guide).
• The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair as necessary before installing a new seat belt assembly.
• Anchor bolts are deformed or worn out.
• The front seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in which the air bags are deployed.

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses