OEM Restraints System Part Replacement Search
2012 Toyota Prius (Hybrid)
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
REV: 11/2014
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and center airbag sensor assembly: [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,INTERIOR (RR); MODULE,AIRBAG CONTROL]Deployed airbag(s):
• Steering pad [AIRBAG, STEERING WHEEL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front seat side airbag assembly [AIRBAG,FRONT SEAT]
• If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover or separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
When troubleshooting the SRS, always check for DTCs before disconnecting the battery• Steering pad [AIRBAG, STEERING WHEEL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front seat side airbag assembly [AIRBAG & SEAT BACK ASSY]
• Seat position sensor
• Front seat outer belt assembly
• Occupant classification ECU
Perform zero point calibration and sensitivity check if the vehicle is brought to the workshop for repair due to an accident or a collision.
Airbag sensor: If any of the defects is found or a airbag sensor has detected a major collision, replace the airbag sensor with a new one:
• Front airbag sensors
• Side airbag sensors
• Rear airbag sensors
Additionally inspect the:
• Steering wheel
• Instrument panel/ Instrument panel reinforcement
• Front pillar garnish and Headliner
Replace any faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems.
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
