OEM Restraints System Part Replacement Search
2012 Toyota Highlander
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF and remove key.2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
REV: 03/2014
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly.Deployed airbags:
• Steering wheel mounted Airbag, [AIRBAG,STEERING WHEEL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger airbag assembly, [AIRBAG,INSTRUMENT PNL]
• Front seat airbag assembly, [AIRBAG,FRONT SEAT]
• Curtain shield airbag assembly, [AIRBAG,ROOF]
• Center airbag sensor assembly, [MODULE,AIRBAG CONTROL]
• Replace all airbag sensors in the damaged area (anywhere in need of repair) [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,SIDE; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
• If the side airbag was deployed, replace the front seat airbag assembly, front seatback cover and front seat frame with adjuster assembly with the necessary parts in accordance with the extent of the collision damage.
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Perform a diagnostic system check• Steering pad [AIRBAG,STEERING WHEEL]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Front seat airbag assembly [AIRBAG,FRONT SEAT]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Front airbag sensor [AIRBAG SENSOR,FRONT]
• Side airbag sensor [AIRBAG SENSOR,FRT DOOR]
• Side airbag sensor [AIRBAG SENSOR,SIDE]
• Rear airbag sensor [AIRBAG SENSOR,QTR PANEL]
• Front seat outer belt assembly
• SRS wire harness or connector
• It is necessary to replace any airbag sensors in undamaged areas that have registered a major collision, or which exhibit any external damage
• Perform zero point calibration and sensitivity check
Additionally inspect the:
• Steering wheel
• Instrument panel or Instrument panel reinforcement
• Front pillar garnish and Headliner
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
