OEM Restraints System Part Replacement Search
2010 Toyota Sienna
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring.1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
When the cable is disconnected from the negative (-) battery terminal, the memory settings of each system will be cleared. Because of this, be sure to write down the settings of each system before starting work. When work is finished, reset the settings of each system as before. Never use a backup power supply from outside the vehicle to avoid erasing the memory in a system
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
With a front airbag deployment:• Steering wheel mounted Airbag [If Deployed]
• Front passenger airbag assembly [If Deployed]
• Driver side knee airbag assembly [If Deployed]
• Front passenger side knee airbag assembly [If Deployed]
• Center airbag sensor assembly (under console assy)
• The front airbag sensor on the impacted side should be replaced after the steering pad or front passenger airbag assembly has deployed
• Any damaged restraint system part
With a side airbag deployment:
• Front seat airbag assembly [If Deployed]
• Rear seat airbag assembly [If Deployed]
• Center airbag sensor assembly (under console assy)
• The side airbag sensor on the impacted side should be replaced after the front seat side airbag assembly and curtain shield airbag assembly have deployed
• Any damaged restraint system part
With a side curtain airbag deployment:
• Curtain shield airbag assembly [If Deployed]
• Center airbag sensor assembly (under console assy)
• The side airbag sensor on the impacted side should be replaced after the front seat side airbag assembly and curtain shield airbag assembly have deployed
• The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Spiral cable• Steering Pad
• Steering wheel
• Instrument panel
• Instrument panel reinforcement
• Seat position sensor
• Occupant classification ECU
• Seat and seat mounting points
• Seatbelts and seatbelt mounting points
• Front pillar garnish
• Roof headlining
• SRS wire harness or connector
• Non• Deployed Airbag Assys
• Front Airbag Sensor
• Seat Position Sensor
• Occupant Classification ECU
• Side Airbag Sensor
• Rear Airbag Sensor
• Visually inspect and Replace any airbag sensor in undamaged areas that have registered a major collision or exhibit external damage
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
