OEM Restraints System Part Replacement Search
2010 Honda Accord Coupe
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.1. Always turn the ignition switch to LOCK (0)
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before starting work
REV: 02/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
After a collision where the seat belt tensioners deployed, replace these items:• SRS unit [MODULE,AIRBAG CONTROL]
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FENDER]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed front airbag(s)
[AIRBAG, STEERING WHEEL], if deployed
[AIRBAG, INSTRUMENT PNL], if deployed
• Front seat belt(s)
• Front impact sensor(s) [AIRBAG SENSOR,FENDER]
After a collision where the side airbag(s) deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s)
[AIRBAG,SEAT]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Seat frame and related parts
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Front seat belt(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,INTERIOR]
• Roof trim (headliner)
• A-pillar trim
• B-pillar upper trim (4-door)
• C-pillar trim
• Front grab handle
• Rear grab handle (4-door)
• All related trim clips
• Sunvisor
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Before doing any SRS repairs, check the DTCs with the HDS, for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, rear safing sensor, etc.)• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs
• ODS unit operation check
• Inspect the front seat active head restraints.
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
• Front Passenger's Weight Sensor Output Check
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
• After a collision where the side airbag was deployed, inspect the seat-back cover/pad. Replace the seat-back cover/pad if it is damaged.
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
