OEM Restraints System Part Replacement Search
2010 Acura TSX
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before doing any SRS repairs, check for DTCs with the HDS for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, rear safing sensor, etc).Before disconnecting the SRS unit connectors, always disconnect the appropriate SRS parts connectors.
1. Make sure the ignition switch is in LOCK (0), or the vehicle ignition in the OFF mode.
2. Disconnect and isolate the negative cable from the battery.
NOTE: Always disconnect the negative cable from the battery first.
3. Disconnect the positive cable from the battery.
4. Wait at least 3 minutes before starting work
REV: 03/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
If there is a breaking or damage found in harness relevant to the replacement parts shown below, replace it, do not repair.After a collision where the seat belt tensioners deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioners, if depolyed
• Front impact sensors [AIRBAG SENSOR,FRONT]
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• Front impact sensors [AIRBAG SENSOR,FRONT]
• Dashboard, with deployed passenger airbag
After a collision where the side airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim
• Front seat assembly (impact side)
• Seat belt tensioners
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Seat belt tensioner(s)
• Side impact sensor(s) (first) [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,INTERIOR]
• Roof trim (Headliner)
• A-pillar trim
• B-pillar upper trim
• C-pillar trim
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
If there is a breaking or damage found in harness relevant to the replacement parts shown below, replace it, do not repair.• Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting.
• Do the ODS unit operation check
• Inspect Front seat active head restraints
• Inspect all the SRS wire harnesses
• Inspect the cable reel for heat damage [CLOCK SPRING]
• Front Passenger's Weight Sensor Output Check After a Vehicle Collision
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
