OEM Restraints System Part Replacement Search
2009 Audi A8L 6.0L W12/ S8
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. When working on the airbag system, the battery Ground (GND) strap must be disconnected.2. No waiting time is necessary after disconnecting the battery.
3. On vehicles equipped with Audi Telematics by OnStar, switch off emergency (back-up) battery for Telematic/Telephone Control Module prior to disconnecting vehicle battery
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
For a front airbag deployment:• Any Deplyed Airbag
• Battery switch off relay J655
• Both sensors for front airbags on front end
• Airbag control module
• Instrument panel (with a passenger side airbag deployment)
• Self-cancelling ring/coil connector with slip ring (with a driver's side airbag deployment)
• All seatbelts with belt tensioners that have been triggered
• Any damaged restraint system part
For a front side airbag deployment:
• Drivers side aibag (If Deployed)
• Passengers side airbag (If Deployed)
• Lateral acceleration sensor on side where airbag has been triggered
• Seat backrest padding
• Upholstery stables (metal and plastic)
• Airbag control module
• All seatbelts with belt tensioners that have been triggered
• Any damaged restraint system part
•For a rear side airbag deployment:
• Drivers side aibag (If Deployed)
• Passengers side airbag (If Deployed)
• Lateral acceleration sensor on side where airbag has been triggered
• Seat backrest padding
• Upholstery stables (metal and plastic)
• Airbag control module
• All seatbelts with belt tensioners that have been triggered
• Any damaged restraint system part
For a roof airbag deployment:
• Drivers side airbag (If Deployed)
• Passenger side airbag (If Deployed)
• Airbag control module can be used for up to three activations of side curtain airbags and/or belt tensioners. After the third activation, the DTC "control module malfunctioning" will appear.
• Lateral acceleration sensor on side where airbag has been triggered
• Trims pillars A, B, C, D
• All seatbelts with belt tensioners that have been triggered
• Any damaged restraint system part
Airbag control module must be replaced:
• After a driver/front passenger airbag has been triggered
• After side curtain airbag and/or belt tensioner has been triggered three times
• If housing is damaged
• If there is a deformation at channel, in circumference of 200 mm around control module
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
For a front airbag deployment:• Supports for passenger side airbag unit (must not be bent back into place)
• Lateral acceleration sensor if floor pan around sensor has been deformed
• Any restraint system part or wiring identified by diagnostic check
For a side airbag deployment:
• Non-triggered lateral acceleration sensor if floor pan around sensor has been deformed
• Any restraint system part or wiring identified by diagnostic check
For a head airbag deployment:
• Non-triggered lateral acceleration sensor if floor pan around sensor has been deformed
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
