OEM Restraints System Part Replacement Search
2010 Toyota Camry Hybrid
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn ignition switch to OFF2. Disconnect the negative (-) terminal cable is from the battery
3. Wait at least 90 seconds.
REV: 02/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
With a front airbag deployment:• Steering Pad, [AIRBAG,STEERING WHEEL], if deployed
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER], if deployed
• Front passenger airbag assembly, [AIRBAG,INSTRUMENT PNL], if deployed
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Front airbag sensor on the impacted side [AIRBAG SENSOR,FENDER]
With a side airbag deployment:
• If the side airbag was deployed, replace the front seat assembly with a new one [AIRBAG & SEAT ASSY,FRT]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Side airbag sensor on the impacted side [AIRBAG SENSOR,SIDE]
With a side curtain airbag deployment:
• Curtain shield airbag assembly, [AIRBAG,ROOF], if deployed
• Center airbag sensor assembly, [MODULE,AIRBAG CONTROL]
• Side airbag sensor on the impacted side [AIRBAG SENSOR,SIDE]
• Rear airbag sensor on the impacted side [AIRBAG SENSOR,QTR PANEL]
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Perform a diagnostic system checkIf any of these parts have been dropped, or a defect is found (e.g. cracks, dents or any other defects) in any of the housings, brackets or connectors, then replace the part with a new one:
• Steering Pad, [AIRBAG,STEERING WHEEL]
• Front Passenger Airbag Assembly [AIRBAG,INSTRUMENT PNL]
• Driver Side Knee Airbag Assembly [AIRBAG,KNEE BOLSTER]
• Front Seat Side Airbag Assembly [AIRBAG & SEAT ASSY,FRT]
• Curtain Shield Airbag Assembly [AIRBAG,ROOF]
• Center Airbag Sensor Assembly [MODULE,AIRBAG CONTROL]
• Front Airbag Sensor [AIRBAG SENSOR,FENDER]
• Front Seat Inner Belt Assembly
• Seat Position Sensor
• Occupant Classification ECU
• Side Airbag Sensor [AIRBAG SENSOR,SIDE]
• Rear Airbag Sensor [AIRBAG SENSOR,QTR PANEL]
• Front Seat Outer Belt Assembly
Additionally inspect the:
• Steering wheel
• Instrument panel or Instrument panel reinforcement
• Front pillar garnish and Headliner
Occupant Classification precaution:
• Perform zero point calibration and sensitivity check
• Check the flatness of the body side that is equipped with the passenger seat
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
