OEM Restraints System Part Replacement Search
2009 Subaru Outback
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn the ignition switch to OFF.2. Disconnect the ground cable from the battery.
3. Wait for at least 60 seconds before starting work.
REV: 01/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Replace the following parts when the airbag is deployed:1. FRONT COLLISION
1) Driver’s airbag module [AIRBAG,STEERING WHEEL]
2) Passenger’s airbag module [AIRBAG,INSTRUMENT PNL]
3) Driver’s seat belt (Pretensioner)
4) Passenger’s seat belt (Pretensioner)
5) Airbag control module [MODULE,AIRBAG CONTROL]
6) Front sub sensor (L/R) [AIRBAG SENSOR,FENDER]
7) Roll connector [CLOCK SPRING]
8) Instrument panel (for integrating with passenger’s airbag module)
9) Passenger’s side seat cushion pad and frame assembly
2. SIDE COLLISION
1) Airbag control module [MODULE,AIRBAG CONTROL]
2) Satellite safing sensor [AIRBAG SENSOR,FLOOR MTD]
3) Side airbag module (operating side seat backrest) [AIRBAG,FRONT SEAT]
4) Side airbag sensor (operating side) [AIRBAG SENSOR,INTERIOR]
5) Curtain airbag module (operating side) [AIRBAG,ROOF]
6) Curtain airbag sensor (operating side) [AIRBAG SENSOR,INTERIOR]
7) Satellite safing sensor mounting bracket and cover [AIRBAG SENSOR,COVER]
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• Check non-deployed airbags, the mounting points, brackets and Harness and connectors• Seatbelts and seatbelt mounting points
• Sensor brackets, in the area of accident damage
• Steering wheel and steering shaft
• Check the direct type connector of drivers airbag
module, curtain airbag module and pretensioner, etc. for damage, and also check each harness for pinch and connector damage. Replace the harness as a unit if damage is found
• Check the seat cushion frame, backrest, seat rail and headrest for deformation, distortion, crack, and
installing condition and play
• For the passenger’s seat, replace the seat cushion pad and frame assembly with a new part if the seat cushion pad and frame assembly is deformed
or cracked.
• Passenger side seat cushion cover
• Use the Subaru Select Monitor to check whether the drivers seat position sensor and the drivers and
the front left/right seat belt buckle switches are operating normally
• Any restraint system part identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
