OEM Restraints System Part Replacement Search
2023 Toyota Mirai
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring.1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.
REV: 05/2024
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; MODULE,AIRBAG CONTROL]Deployed Airbag(s):
• Steering Pad [AIRBAG,STEERING WHEEL]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front seat airbag assembly
• Front seat airbag sub-assembly RH [AIRBAG,FRT SEAT CUSHION]
• Curtain shield airbag assembly [AIRBAG,ROOF]
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Perform a diagnostic system check• Steering Pad [AIRBAG,STEERING WHEEL]
• Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front seat airbag assembly; seat assy
• Front seat airbag sub-assembly RH; seat assy
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front Airbag Sensor
• Seat Position Sensor
• Occupant Classification ECU
• Side Airbag Sensor
• Rear Airbag Sensor
• Steering wheel
• Instrument panel/ Instrument panel reinforcement
• Front pillar garnish and Headliner
• SRS wire harness/ connectors
• If any of the SRS parts are dropped, or if any cracks, dents or other defects are found, replace them with new parts
• Perform the zero point calibration and sensitivity check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
