OEM Restraints System Part Replacement Search
2007 Acura MDX
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs (make sure the HDS is loaded with the latest software); refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.)Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped)
Before removing the SRS unit connectors, always disconnect the appropriate associated SRS parts connectors.
1. Make sure the ignition switch is in LOCK (0)
2. Disconnect the negative cable from the battery
3. Wait at least 3 minutes before beginning work
REV: 01/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Note: Always install the SRS unit, all impact sensors, the rear safing sensor and the drivers front airbag securely with new TORX bolts. Additionally a replacement side seat airbag would require new mounting nuts and when servicing the passenger's front airbag, replace the mounting bolts with new ones.After a collision where the seat belt tensioners deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioners
• If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
• Front impact sensors [AIRBAG SENSOR,FENDER]
• Any damaged restraint system part
After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Steering Wheel Mounted Airbag, If Deployed [AIRBAG,STEERING WHEEL]
• Instrument Panel Airbag, If Deployed [AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
• Front impact sensors [AIRBAG SENSOR,FENDER]
• Dashboard, if the Instrument Panel Airbag deployed
• Any damaged restraint system part
After a collision where the side airbag(s) deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Drivers side seat airbag [AIRBAG,FRONT SEAT], if deployed If you are replacing a deployed seat airbag, replace the reinforcing cloth rear hooks
• Passenger's side seat airbag [AIRBAG,FRONT SEAT], if deployed If you are replacing a deployed seat airbag, replace the reinforcing cloth rear hooks
• Side impact sensor(s) (first) for the side(s) that deployed [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) for the side(s) that deployed [AIRBAG SENSOR,QTR PANEL]
• B-pillar lower trim
• Complete seat frame, for the side(s) that deployed
• Any damaged restraint system part
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
• SRS unit [MODULE,AIRBAG CONTROL]
• Left side curtain airbag [AIRBAG,ROOF], if deployed
• Right side curtain airbag [AIRBAG,ROOF], if deployed
• Seat belt tensioner(s) for the side(s) that deployed
• If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
• Side impact sensor(s) (first) for the side(s) that deployed [AIRBAG SENSOR,SIDE]
• Side impact sensor(s) (second) for the side(s) that deployed [AIRBAG SENSOR,QTR PANEL]
• Rear safing sensor [AIRBAG SENSOR,INTERIOR]
• Roll rate sensor [AIRBAG SENSOR,INTERIOR]
• Roof trim/ Headliner
• A pillar trim
• B pillar upper trim
• Quarter pillar trim
• Front grab handle
• Rear grab handle
• All related trim clips
• Sunvisor
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• After a vehicle collision, do the ODS unit operation check• ODS Unit; Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting
• After a vehicle collision, inspect the front seat active head restraints
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel [CLOCK SPRING]
• Seatbelts and seatbelt mounting points
• Seats and seat mounting points
• Front passenger's weight sensors
• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. If the airbag is frayed, or has any other visible damage, replace it. Do not attempt to repair an airbag. If the clips are stress-whitened, replace them with new ones.
• Front Passenger's Weight Sensor, SRS Indicator Is On With SRS DTC 81-79 After Body Shop Repair 2007 -2008 (Acura ServiceNews Article 07110E )
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
