DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch OFF
2. Disconnect the battery negative cable from the battery
3. Wait at least three minutes before beginning work.

REV: 08/2012

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the front airbag(s) deployed after a collision, replace the following items.
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt pretensioner(s)
• Front impact sensor [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses

When the seat belt pretensioner(s) deployed after a collision, replace the following items.
• Seat belt pretensioner(s)
• SRSCM (if B1658 detected) [MODULE,AIRBAG CONTROL]
• Front impact sensor [AIRBAG SENSOR,FRONT]
• SRS wiring harnesses

When the side/curtain airbag(s) deployed after a collision, replace the following items.
• SRSCM [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG & SEAT ASSY,FRT; AIRBAG,ROOF]
• Side impact sensor(s) for the deployed side(s) [AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL]
• SRS wiring harnesses
• When the side airbag deployed after a collision, replace the seatback as an assembly

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Before doing any SRS repairs, use the Hi-Scan Pro to check for DTCs.
• Inspect the clock spring for heat damage. If any damage found, replace the clock spring.
• WCS reset and accuracy check
• If the crash pad is damaged when the passenger airbag is deployed, replace the damaged crash pad and passenger airbag together