OEM Restraints System Part Replacement Search
2007 Jaguar S-Type
|
Share:
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Make sure the wheels are in the straight-ahead position2. Turn ignition switch to LOCK and remove key.
3. Remove battery cover.
4. Disconnect battery ground cable.
5. Wait at least 1 minute.
•••Radio code saving devices must not be used when conducting work on airbags.
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait one minute. Failure to follow this instruction may result in personal injury
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
For a front airbag deployment:• Deployed airbag modules
• Front and rear safety belt assemblies that were in use during deployment
• RCM module after 5 separate deployments
• Air bags modules with discolored or damage trim covers
• Any damaged or defective restraint system part
For a side airbag deployment:
• Front and rear safety belt assemblies that were in use during deployment
• RCM module after 5 separate deployments
• Air bags modules with discolored or damage trim covers
•Any damaged or defective restraint system part
For a curtain airbag deployment:
• Curtain airbag module [Roof airbag]
• New nylon thread forming inserts must be used ever time the screws are removed from the side air curtain
• Air bags modules with discolored or damage trim covers
• Any damaged or defective restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
For a front airbag deployment:• Clockspring
• Front and rear safety belt assemblies not in use during deployment
• Seats and seat mounting points
• Safety belt buckles
• Safety belt buckle support assemblies (slider bar)
• Child safety seat tether brackets and hardware
• RCM module mounting points
• ECS module
• Airbag trim covers
• All airbag sensors
• All sensor brackets and mounting points
• Active Head Restraint System
• Sensor wiring pigtail
• Any restraint system part or wiring identified by the restraint diagnostic checks
For a side airbag deployment:
• Front and rear safety belt assemblies not in use during deployment
• Seats and seat mounting points
• Safety belt buckles
• Safety belt buckle support assemblies (slider bar)
• Child safety seat tether brackets and hardware
• All airbag sensors
• All sensor brackets and mounting points
• Active Head Restraint System
• RCM module mounting points
• ECS module
• Any restraint system part or wiring identified by the restraint diagnostic checks
For a curtain airbag deployment:
• Headliner
• A, B, and C pillar trim panels
• Front and rear safety belt assemblies not in use during deployment
• Seats and seat mounting points
• Safety belt buckles
• Safety belt buckle support assemblies (slider bar)
• Child safety seat tether brackets and hardware
• Active Head Restraint System
• ECS module
• All airbag sensors
• All sensor brackets and mounting points
• Any restraint system part or wiring identified by the restraint diagnostic checks
Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.