OEM Restraints System Part Replacement Search
2007 Chrysler Aspen
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Disconnect and isolate the battery negative (ground) cable.2. Wait two minutes for the system capacitor to discharge before further system service.
REV: 08/2011•
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Any vehicle which is to be returned to use following a Supplemental Restraint System (SRS) component deployment must have the deployed restraints replaced.When Driver Airbag has deployed:
• Drivers Airbag [AIRBAG,STEERING WHEEL]
• Steering Wheel
• Clockspring
• Steering Column Assembly including Intermediate Shaft/Coupler
• Seat belt tensioners
• All Seat Belt Retractors and Buckles in use
When Passenger Airbag has deployed:
• Passenger Airbag [AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• Passenger Airbag Wiring Harness or Connector if available (Must use approved wire crimping tool and splices)
When Side Curtain Airbag has deployed:
• Side Curtain airbag [AIRBAG,ROOF]
• Headliner upper A, B, C and D pillar trim on the same side of the vehicle as the deployed airbag
• All Seat Belt Retractors and Buckles in use
The seat belt tensioners are deployed by the same signal that deploys the driver and passenger airbags and must also be replaced if either front airbag has been deployed
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
• It is critical that the mounting surfaces and mounting brackets for the Occupant Restraint Controller (ORC), side impact sensors and front impact sensors be closely inspected and restored to their original conditions following any vehicle impact damage [MODULE,AIRBAG CONTROL; AIRBAG SENSOR,FRONT; AIRBAG SENSOR,INTERIOR (FRT); AIRBAG SENSOR,INTERIOR (RR)]• Lower anchors and tether for children (LATCH)
• Inspect all trim panels
• On vehicles with an optional sunroof, the sunroof and the sunroof drain tubes and hoses must be closely inspected following a side curtain airbag deployment.
• The seat belt tensioners must be inspected if the side curtain airbag has been deployed
• All other vehicle components should be closely inspected following any SRS component deployment, but are to be replaced only as required by the extent of the visible damage incurred
When Passenger Airbag has deployed:
• Upper Instrument Panel Pad
• Instrument Panel
There are two methods by which an airbag or seat belt tensioner may be connected to the vehicle electrical system.
1) The first method involves a short pigtail harness and connector insulator that are integral to the airbag or tensioner unit and are replaced as a unit with the service replacement airbag or seat belt tensioner unit.
2) The second method involves a wire harness takeout and connector insulator (squib circuits) that are connected directly to the air bag or tensioner initiator. The heat created by the initiator during an airbag or tensioner deployment will cause collateral damage to a directly connected wire harness take out and connector insulator. Therefore, these direct-connect type take outs and connector insulators must be repaired following an airbag or seat belt tensioner deployment
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
