OEM Restraints System Part Replacement Search


2020 Lexus UX Hybrid

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired.
Before repairs, remove the airbag sensor assemblies if impacts are likely to be applied to the sensor during repairs

1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.

REV: 07/2020

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and airbag sensor assembly (center airbag sensor assembly). [AIRBAG SENSOR,FRONT, AIRBAG SENSOR,FRT DOOR, AIRBAG SENSOR,SIDE, AIRBAG SENSOR,QTR PANEL, MODULE,AIRBAG CONTROL]

[Replace deployed airbags]
• Horn button assembly [AIRBAG,STEERING WHEEL]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER]
• Instrument panel passenger without door airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assemblies [AIRBAG,ROOF]
• Front seat airbag assemblies [AIRBAG,FRONT SEAT]
• Front seat cushion airbag assembly RH [AIRBAG COVER,SEAT]
• Front seat outer belt assemblies
• Rear seat 3 point type outer belt assemblies
• Rear seat airbag assemblies [AIRBAG,QTR PANEL]


• If the front seat cushion airbag assembly RH has been deployed, replace the front seat cushion airbag assembly RH, front seat adjuster assembly RH, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage. [AIRBAG COVER,SEAT]


PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Always check for DTCs before disconnecting the cable from the negative (-) battery terminal.
Visually check the airbag sensors in undamaged areas for defects.
If any defects are found or an airbag sensor has detected a major collision, replace the airbag sensor with a new one.

• Airbag sensor assembly [MODULE,AIRBAG CONTROL]
• Front airbag sensors [AIRBAG SENSOR,FRONT]
• Door side airbag sensors [AIRBAG SENSOR,FRT DOOR]
• Side airbag sensor assemblies [AIRBAG SENSOR,SIDE]
• Floor side airbag sensor[AIRBAG SENSOR,FLOOR]
• Rear airbag sensors [AIRBAG SENSOR,QTR PANEL]
• Horn button assembly [AIRBAG,STEERING WHEEL]
• Lower No. 1 instrument panel airbag assembly [AIRBAG,KNEE BOLSTER]
• Instrument panel passenger without door airbag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assemblies [AIRBAG,ROOF]
• Front seat airbag assemblies [AIRBAG,FRONT SEAT]
• Front seat outer belt assemblies
• Rear seat 3 point type outer belt assemblies
• Rear seat airbag assemblies [AIRBAG,QTR PANEL]
• Front seat cushion airbag assembly RH [AIRBAG COVER,SEAT]

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses