OEM Restraints System Part Replacement Search


2020 Lexus LX 570

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to OFF and remove key.
2. Disconnect and isolate negative battery cable.
3. Wait at least 90 seconds.

NOTICE:

w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected

REV: 12/2019

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; AIRBAG SENSOR,FLOOR; MODULE, AIRBAG CONTROL]

• Deployed Steering wheel pad [AIRBAG, STEERING WHEEL]
• Deployed Front passenger airbag assembly [AIRBAG,INSTRUMENT PNL]
• Deployed Driver side knee airbag assembly, [AIRBAG,KNEE BOLSTER]
• Deployed Front passenger side knee airbag assembly, [AIRBAG,KNEE BOLSTER]
• Deployed Curtain shield airbag assembly, [AIRBAG,ROOF]
• Deployed Side seat airbag [AIRBAG,FRONT SEAT; AIRBAG & SEAT ASSY,MIDDLE]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

• Steering pad [AIRBAG, STEERING WHEEL]
• Front passenger airbag
• Curtain shield airbag [AIRBAG,ROOF]
• Front seat airbag [AIRBAG,FRONT SEAT]
• Driver side knee airbag [AIRBAG,KNEE BOLSTER]
• Front passenger side knee airbag [AIRBAG,KNEE BOLSTER]
• Rear seat side airbag [AIRBAG & SEAT ASSY,MIDDLE]
• Rear floor airbag sensor [AIRBAG SENSOR,FLOOR]
• Seat belt pretensioner
• Center airbag sensor [MODULE, AIRBAG CONTROL]
• Front airbag sensor [AIRBAG SENSOR,FRONT]
• Side airbag sensor [AIRBAG SENSOR,FRT DOOR]
• Rear airbag sensor [AIRBAG SENSOR,QTR PANEL]
• Occupant classification ECU
• Perform initialization of the occupant classification ECU
• Seat position sensor [AIRBAG SENSOR,SEAT TRACK]
• Replace the faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning systems

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses