OEM Restraints System Part Replacement Search
2007 Suzuki Aerio
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Turn steering wheel so that vehicle wheels (front tires) are pointing straight ahead.2. Disconnect negative (-) cable at battery.
3. Turn ignition switch to "LOCK" position and remove key.
4. Remove "AIR BAG" fuse from fuse box (driver side of instrument panel).
5. Disconnect yellow connector of contact coil and combination switch assembly as follows:
a) Release locking of lock slider.
b) After unlocked, disconnect connector.
6. In case of passenger air bag module, pull out glove box while pushing its stopper from both right and left sides and disconnect yellow connector of passenger air bag (inflator) module as follows:
a) Release locking of lock slider.
b) After unlocked, disconnect connector.
7. In the case of side air bag module, disconnect yellow connector of side air bag module under front seat cushion.
a) Release locking of lock slider.
b) After unlocked, disconnector connector.
NOTE:
With "AIR BAG" fuse removed and ignition switch ON, "AIR BAG" warning lamp will be ON.
This is normal operation and does not indicate an air bag system malfunction.
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
With a front airbag deployment:• Driver and passenger air bag (inflator) modules
• Driver and passenger seat belt pretensioners
• Sensing and diagnostic module (SDM) after detecting such collision as to meet deployment conditions
• Forward sensors
• Instrument panel
• Any damaged restraint system part
With a side airbag deployment:
• Applicable side air bag (inflator) module(s)
• Side sensor
• Sensing and diagnostic module (SDM)
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
With a front airbag deployment:• Steering column and shaft joints
• Steering column bracket and capsules
• Steering wheel
• Driver air bag (inflator) module trim cover
• Air bag module and sensor wire harnesses and connectors
• Contact coil and combination switch assembly
• OCM
• OCM connector and terminals
• Instrument panel member and reinforcement
• Passenger air bag (inflator) module trim cover
• Seat belts and mounting points
• "AIR BAG" warning lamp
• SDM connector or lead wire
• SDM terminals
• Any restraint system part or wiring identified by diagnostic check
With a side airbag deployment:
• "AIR BAG" warning lamp
• Side air bag module trim covers
• Side air bag module wire harnesses and connectors
• OCM
• OCM connector and terminals
• Passenger seat assembly
• Driver seat position sensor, sensor bracket, seat adjuster, and sensor connector or lead wire
*This matrix does not currently contain all production vehicles sold in the United States. The contents were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. Updates and additions will be posted as they become available. To ensure that you are using the most recent information, always refer to vehicle maker technical information.
