OEM Restraints System Part Replacement Search

---

2010 Suzuki Equator

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

Before servicing the SRS:
1. Turn ignition switch OFF.
2. Disconnect both battery terminals.
3. Wait at least three minutes.

For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed

REV: 10/2012

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

For frontal collision:
• If the driver air bag has deployed: REPLACE Install with new fasteners [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners [AIRBAG SENSOR,FRONT]
• Replace Activated seat belt pre-tensioner assemblies, install with new fasteners
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners. [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING/LVR,STRG ]
• If the passenger front air bag has deployed: REPLACE the instrument panel assembly.

For side and rollover collision:
• If the LH side curtain air bag has deployed: REPLACE the LH side curtain air bag module. [AIRBAG,ROOF]
• If the RH side curtain air bag has deployed: REPLACE the RH side curtain air bag module. [AIRBAG,ROOF]
• If the front LH side air bag has deployed: REPLACE front LH seatback assembly [AIRBAG & SEAT BACK ASSY]
• If the front RH side air bag has deployed: REPLACE front RH seatback assembly [AIRBAG & SEAT BACK ASSY]
• If any of the SRS components have deployed: REPLACE the side air bag (satellite) sensor on the collision side with new fasteners. [AIRBAG SENSOR,SIDE]
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners. [MODULE,AIRBAG CONTROL]
• Replace Activated seat belt pre-tensioner assemblies, install with new fasteners

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Conduct “DTC check” using SDT and “AIR BAG” warning lamp.
• Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
• Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct-connect harness connector is damaged, the harness must be replaced.
• Inspect all seat belt assemblies including retractors and attaching hardware after any collision
• SUZUKI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Seat belt pre-tensioner should be replaced even if the seat belts are not in use during a frontal collision in which the air bags are deployed.

For frontal collision:
• Confirm seat belt pre-tensioner activation using SDT only.
• Seat belt pre-tensioner assemblies
• Steering wheel
• Occupant classification system (Passenger seat)
• Harness and connectors
• Check instrument panel

For side and rollover collision:
• Curtain air bag
• Seat back on the collision side.
• Harness and connectors
• If damaged—REPLACE the front seatback assembly
• Side air bag (satellite) sensor on the collision side
• Seat on the collision side
• Center inner pillar on the collision side for damage (dents, cracks, deformation).
• Trim/headlining