OEM Restraints System Part Replacement Search
2007 INFINITI FX
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.
1. Turn the push-button ignition switch to OFF position.
2. Disconnect both battery cables
3. Wait at least 3 minutes.
NOTE: Always use CONSULT-III to perform self-diagnosis as a part of each function inspection after finishing work
REV: 09/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
FOR FRONTAL COLLISION:• If the driver air bag has deployed:
REPLACE Install with new fasteners [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners• have been activated: REPLACE the crash zone sensor and bracket with new fasteners [AIRBAG SENSOR,FRONT]
• Driver or passenger seat belt pre-tensioner assemblies with new fasteners, if deployed
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable
[CLOCK SPRING]
FOR SIDE AND ROLLOVER COLLISION:
• If the side curtain air bag LH has deployed: REPLACE the side curtain air bag module LH [AIRBAG,ROOF]
• If the side curtain air bag RH has deployed: REPLACE the side curtain air bag module RH [AIRBAG,ROOF]
• If the front side air bag LH has deployed: REPLACE front seatback assembly LH. [AIRBAG,FRONT SEAT]
• If the front side air bag RH has deployed: REPLACE front seatback assembly RH [AIRBAG,FRONT SEAT]
• Side air bag (satellite) sensor LH or RH: REPLACE the satellite sensor on the collision side with new fasteners [AIRBAG SENSOR,SIDE]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners [MODULE,AIRBAG CONTROL]
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)FOR FRONTAL COLLISION:
• Non-deployed airbags
• Steering wheel
• Occupant classification system
• Wiring harness, connectors and terminals
• Visually check instrument panel assembly for damage
• All seat belt assemblies including retractors and attaching hardware. If any component of seat belt assembly is questionable, do not repair. Replace the entire seat belt assembly
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.
FOR SIDE AND ROLLOVER COLLISION:
• Non-deployed airbags
• Satellite sensor (LH or RH)
• All seat belt assemblies including retractors and attaching hardware. If any component of seat belt assembly is questionable, do not repair. Replace the entire seat belt assembly
• If the front LH or front RH side air bag modules have NOT deployed: Visually check the seat on the collision side
• Center inner pillar on the collision side for damage (dents, cracks, deformation), repair if damaged
• Trim/headliner
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
