OEM Restraints System Part Replacement Search


2007 INFINITI G35/G37/Q40 Sedan

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.

1. Turn the ignition switch OFF.
2. Disconnect both battery cables
3. Wait at least 3 minutes.

REV: 02/2015

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

FOR FRONTAL COLLISION When SRS is activated in a collision:
• If the driver air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners. [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners. [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer), if deployed
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners [MODULE,AIRBAG CONTROL]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING]
• If the front passenger air bag has deployed: REPLACE the instrument panel assembly. (integrated type)
• Always replace instrument panel pad following front passenger air bag deployment

FOR SIDE AND ROLLOVER COLLISION When SRS is activated in a collision:
• If the side curtain air bag LH has deployed: REPLACE the side curtain air bag module LH. [AIRBAG,ROOF]
• If the side curtain air bag RH has deployed: REPLACE the side curtain air bag module RH. [AIRBAG,ROOF]
• If the front side air bag LH has deployed: REPLACE front seatback assembly LH. [AIRBAG,FRONT SEAT and seat components]
• If the front side air bag RH has deployed: REPLACE front seatback assembly RH. [AIRBAG,FRONT SEAT and seat components]
• If any of the SRS components have deployed: REPLACE the side air bag (satellite) sensor on the collision side with new fasteners [AIRBAG SENSOR,SIDE]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners. [MODULE,AIRBAG CONTROL]
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer), if deployed

NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

For a front airbag deployment:
• Airbag modules that have not deployed
• Steering wheel and Steering wheel harness, connectors and terminals
• Seat belt pre-tensioner assemblies (All applicable locations: buckle, retractor, lap outer)
• Check the center inner pillar on the collision side for damage (dents, cracks, deformation, etc.)
• If the center pillar inner has been damaged, REPLACE the seat belt pre-tensioner assembly
• Occupant classification system (Passenger seat)
• Wiring harness, connectors and terminals. If damaged • REPLACE the damaged harness. Do not attempt to repair, splice or modify any SRS harness.
• Instrument panel (if damaged, replace with new bolts)
• Seatbelts and seatbelt mounting points
• Seats and seat mounting points.
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

For a side airbag deployment:
• Airbag modules that have not deployed
• Seats and seat mounting points.
• Check the center inner pillar on the collision side for damage (dents, cracks, deformation, etc.)
• Seatbelts and seatbelt mounting points
• Occupant classification system (Passenger seat)
• Trim/headliner
• Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
• If the center pillar inner has been damaged, REPLACE the seat belt pre-tensioner assembly
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

Additional Information


*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.


Related I-CAR Courses