OEM Restraints System Part Replacement Search
2007 INFINITI G35 Coupe
Share:
|
Print
Print
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
WARNING:To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance should be performed by an authorized NISSAN/INFINITI dealer.
1. Turn the ignition switch OFF.
2. Disconnect both battery cables
3. Wait at least 3 minutes.
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interference between the window edge and the vehicle when the door is opened/closed. During normal operation, the window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic window function will not work with the battery disconnected.
REV: 01/2011
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
FOR FRONTAL COLLISION:• If the driver air bag has deployed: REPLACE Install with new fasteners [AIRBAG,STEERING WHEEL]
• If the front passenger air bag has deployed: REPLACE Install with new fasteners [AIRBAG,INSTRUMENT PNL]
• If any of the front air bags or seat belt pre-tensioners have been activated: REPLACE the crash zone sensor and bracket with new fasteners. [AIRBAG SENSOR,FRONT]
• Seat belt pre-tensioner
assemblies, if deployed
• If any of the SRS components have been activated: REPLACE the diagnosis sensor unit. Install with new fasteners [AIRBAG SENSOR,INTERIOR]
• If the driver front air bag has deployed: REPLACE the spiral cable [CLOCK SPRING]
• Always replace instrument panel pad following front passenger air bag deployment
• Any damaged restraint system part
FOR SIDE COLLISION:
• If the side curtain air bag LH has deployed: REPLACE the side curtain air bag module LH. [AIRBAG,ROOF]
• If the side curtain air bag RH has deployed: REPLACE the side curtain air bag module RH. [AIRBAG,ROOF]
• If the front side seat air bag LH has deployed: REPLACE All parts of front seatback (including front seatback frame) with front side air bag module LH
• If the front side seat air bag RH has deployed: REPLACE All parts of front seatback (including front seatback frame) with front side air bag module RH
• If any of the SRS components have deployed: REPLACE the side air bag (satellite) sensor on the collision side with new fasteners [AIRBAG SENSOR,SIDE]
• If any of the SRS components have deployed: REPLACE the diagnosis sensor unit with new fasteners [AIRBAG SENSOR,INTERIOR]
• Seat belt pre-tensioner
assemblies, if deployed
• Any damaged restraint system part
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)FOR FRONTAL COLLISION:
• Airbag modules that have not deployed
• Steering wheel and Steering wheel harness, connectors and terminals
• Seat belt pre-tensioner assemblies
(All applicable locations: buckle,
retractor, lap outer)
• If the center pillar inner has been damaged, REPLACE the seat belt pre-tensioner assembly
• Wiring harness, connectors and terminals. If damaged • REPLACE the damaged harness. Do not attempt to repair, splice or modify any
SRS harness.
• Instrument panel (if damaged, replace with new bolts)
• Seatbelts and seatbelt mounting points
• Seats and seat mounting points
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so
could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation is noted.
• Any restraint system part or wiring identified by diagnostic check
FOR SIDE COLLISION:
• Check the center inner pillar on the collision side for damage (dents, cracks, deformation)
• Check for visible signs of damage (dents, cracks, deformation) of the interior trim/headlining on the collision side
• Airbag modules that have not deployed
• Seats and seat mounting points.
• Check for visible signs of damage (dents, tears, deformation, etc.) of the center pillar (sedan)/lock pillar (coupe) on the collision side. If damaged • Remove the side curtain air bag module, Check for visible signs of damage (tears etc.) of the side curtain air bag module
• Seatbelts and seatbelt mounting points.
• Replace any seat belt assembly (including anchor bolts) if: The seat belt attaching point was damaged in an accident
• Trim/headliner
• Do not attempt to repair, splice or modify any SRS harness.
• NISSAN recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so
could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation is noted.
• Any restraint system part or wiring identified by diagnostic check
| Additional Information |
*This matrix does not currently contain all production vehicles sold in the United States. Please refer back to this page frequently to ensure the most up-to-date information. The following charts were developed in cooperation with AudaExplore, a Solera company. The contents are based on the information available at the time of publication. To ensure that the most recent information is used, always refer to the vehicle maker's technical information before working with airbags and other passive restraint systems.
