OEM Partial Part Replacement Search
2019 Lincoln Continental
Click the links below for the OEM repair information website (note: additional purchase may be required for a subscription to each OEM); How To Use The OEM Partial Part Replacement Search; I-CAR Best Practice: Disassembly of a Steel Service Part at a Factory Seam; and additional RTS portal information such as Collision Repair News articles, OEM position statements, publications, and additional resources.
Front
Front Lower Rail |
|
Sectioning:
Single OEM Location |
|
Partial Part At Factory Seam:
Single OEM Location |
Front Upper Rail |
|
Sectioning:
No OEM Procedure |
|
Partial Part At Factory Seam:
OEM Procedure(s) Available |
Side
Outer Uniside |
|
Sectioning:
OEM Procedure(s) Available |
|
Note: Does NOT have outer quarter panel w/rolled hem flange |
Uniside Reinforcement |
|
Sectioning:
OEM Warning, Do Not Section |
Inner Uniside |
|
Sectioning:
No OEM Procedure |
Per 2019 Lincoln Continental Workshop manual:
NOTE: The roof side rail is constructed of dual phase (DP) 1000 steel and cannot be sectioned. It must be replaced at factory seams.
"NOTE: The B-pillar and B-pillar reinforcement are constructed of Boron steel and cannot be sectioned. They must be replaced at factory seams."
"NOTE: The rocker panel reinforcement is constructed of Martensitic steel and cannot be sectioned. It must be replaced at factory seams."
Rear
Rear Rail |
|
Sectioning:
OEM Warning, Do Not Section |
|
Partial Part At Factory Seam:
No OEM Procedure |
Trunk Floor |
|
Sectioning:
Single OEM Location |
|
Partial Part At Factory Seam:
Single OEM Location |
Rear Body Panel |
|
Sectioning:
No OEM Procedure |
Per 2019 Lincoln Continental Workshop manual:
"The rear side member is manufactured from DP800 steel and cannot be sectioned. Replace at factory seams only.
| Additional Information | |