OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn the ignition switch to the LOCK position
2. Disconnect the negative battery cable
3. Wait for 1 min or more to allow the backup power supply of the SAS control module to deplete its stored power.

REV: 01/2016

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

• Driver's airbag [AIRBAG,STEERING WHEEL], (if deployed)
• Passenger's Airbag [AIRBAG,INSTRUMENT PNL], (if deployed)
• Curtain Shield Airbag [AIRBAG,ROOF], (if deployed)
• Be sure to replace the seat belt once the load limiter operates

Side Air Bag Module Handling:
• After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts [AIRBAG,FRONT SEAT]

SAS Control Module Handling:
• Once the air bags and pretensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one [MODULE,AIRBAG CONTROL]

Crash Zone Sensor Handling:
• Once the air bags and pretensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one [AIRBAG SENSOR,FRONT]

Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one [AIRBAG SENSOR,SIDE; AIRBAG SENSOR,QTR PANEL]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Always use the on-board diagnostic to diagnose the air bag module and the pre-tensioner seat belts to verify that they have no malfunction

Air Bag Wiring Harness Repair:
• If a problem is found in the air bag wiring harness, always replace the wiring harness with a new one

Seat Weight Sensor Handling:
• When the vehicle has been involved in a collision, perform the seat weight sensor inspection using the M MDS