OEM Restraints System Part Replacement Search

2013 Toyota Venza

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1.Turn ignition switch off (LOCK position) and remove key
2. Disconnect and isolate negative battery cable.
3. Wait 90 seconds.

Before using an electric welder on the vehicle, remove any SRS parts around the area being repaired

REV: 12/2015

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly. [AIRBAG SENSOR,FRONT; AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL; MODULE,AIRBAG CONTROL]

• Steering pad [AIRBAG,STEERING WHEEL] [if deployed]
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER] [if deployed]
• Front passenger air bag assembly [AIRBAG,INSTRUMENT PNL] [if deployed]
• Curtain shield airbag assembly [AIRBAG,ROOF] [if deployed]
• If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat frame assembly with adjuster, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage. [AIRBAG,FRONT SEAT]
• Center airbag sensor assembly [MODULE,AIRBAG CONTROL]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Always check for DTCs before disconnecting the battery
• Steering pad [AIRBAG,STEERING WHEEL]
• Spiral cable [CLOCK SPRING]
• Steering wheel
• Driver side knee airbag assembly [AIRBAG,KNEE BOLSTER]
• Front passenger air bag assembly [AIRBAG,INSTRUMENT PNL]
• Curtain shield airbag assembly [AIRBAG,ROOF]
• Front seat side airbag assembly [AIRBAG & SEAT ASSY,FRT]
• Front seat outer belt pretensioner
• Wire harnesses and connectors
• Seat position sensor
• Occupant classification ECU
• Front airbag sensor [AIRBAG SENSOR,FRONT]
• Door side airbag sensor [AIRBAG SENSOR,FRT DOOR]
• Rear airbag sensor [AIRBAG SENSOR,QTR PANEL]
• Front pillar garnish and roof headlining assembly
• Replace any faulty seat belt components (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting a vehicle that was in a collision, be sure to check all of the seat belt systems regardless of whether or not the system was activated in the collision. Replace any damaged or malfunctioning components.



Additional Information