OEM Restraints System Part Replacement Search

2011 Mazda MX-5 Miata

Print

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1. Turn ignition switch to LOCK position.
2. Disconnect the negative battery cable
3. Wait for 1 min or more to allow the backup power supply of the SAS control module to deplete its stored power

REV: 12/2015

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

• Driver's airbag [AIRBAG,STEERING WHEEL], [if deployed]
• Passenger's Airbag [AIRBAG,INSTRUMENT PNL], [if deployed]

Side Air Bag Module Handling:
• LT side: After a side air bag has operated (deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts [AIRBAG,FRONT SEAT]

Seat Weight Sensor Handling:
RT Side: Always replace the front passenger seat and seat weight sensor with new ones after the front or side air bags have operated (deployed) [AIRBAG & SEAT ASSY,FRT]

SAS Control Module Handling:
• Once the air bags and pretensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one [MODULE,AIRBAG CONTROL]

Crash Zone Sensor Handling:
• Once the air bags and pretensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one [AIRBAG SENSOR,FRONT]

Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one [AIRBAG SENSOR,QTR PANEL]

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Always use the on-board diagnostic to diagnose the air bag module and the pre-tensioner seat belts to verify that they have no malfunction

Air Bag Module, Pre-tensioner Seat Belt Reuse:
• Before reusing a live (undeployed) air bag module and the pre-tensioner seat belts, always use the onboard diagnostic to diagnose the air bag module and the pre-tensioner seat belts to verify that they have no malfunction.

Air Bag Wiring Harness Repair:
• If a problem is found in the air bag wiring harness, always replace the wiring harness with a new one

Seat Weight Sensor Handling:
• When the vehicle has been involved in a collision, perform the seat weight sensor inspection using the M MDS
• If the collision is not hard enough to cause the front or side air bags to operate (deploy), inspect the seat weight sensor and replace it if there is any malfunction.
Additional Information