OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.

1. Turn the ignition switch off.
2. Disconnect both battery cables
3. Wait at least 3 minutes.

REV:02/2025

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

FOR FRONTAL COLLISION When SRS has deployed in a collision:

• Driver air bag module
• Knee air bag module LH
• Front passenger air bag module
• Knee air bag module RH
• Crash zone sensor
• Seat belt pre-tensioner assemblies
(All applicable locations: buckle, retractor, lap outer)
• Air bag diagnosis sensor unit
• Steering wheel
• Spiral cable
• Occupant classification system (Passenger seat)
• Harness and connectors
• Instrument panel assembly

FOR SIDE AND ROLLOVER COLLISION When SRS has deployed:

• Side curtain air bag module LH/RH
• Front side air bag module LH/RH
• Front center air bag module
• Rear side air bag module LH/RH
• Front side air bag satellite sensor (LH or RH)
• Rear side air bag satellite sensor (LH or RH)
• Door satellite sensor (LH or RH)
• Air bag diagnosis sensor unit
• Seat belt pre-tensioner assemblies
(All applicable locations: buckle, retractor, lap outer)
• Center inner pillar
• Trim/headlining
• Door-mounted curtain air bag module LH/RH
• Occupant classification system (Passenger seat)
• Pop-up roll bar assemblies



Inspect all seat belt assemblies including retractors and attached hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation was noted. Seat belt pre-tensioners should be replaced even if the seat belts were not in use during a frontal collision in which the air bags were deployed.

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

Perform self-diagnosis using CONSULT or air bag warning lamp.

FOR FRONTAL COLLISION : When SRS has deployed in a collision:
• Driver air bag module
• Knee air bag module LH
• Front passenger air bag module
• Knee air bag module RH
• Crash zone sensor
• Seat belt pre-tensioner assemblies
(All applicable locations: buckle, retractor, lap outer)
• Air bag diagnosis sensor unit
• Steering wheel
• Spiral cable
• Occupant classification system (Passenger seat)
• Harness and connectors
• Instrument panel assembly




FOR SIDE AND ROLLOVER COLLISION: When SRS has deployed in a collision:
• Side curtain air bag module LH/RH
• Front side air bag module LH/RH
• Front center air bag module
• Rear side air bag module LH/RH
• Front side air bag satellite sensor (LH or RH)
• Rear side air bag satellite sensor (LH or RH)
• Door satellite sensor (LH or RH)
• Air bag diagnosis sensor unit
• Seat belt pre-tensioner assemblies
(All applicable locations: buckle, retractor, lap outer)
• Seat (with front side air bag)
• Center inner pillar
• Trim/headlining
• Door-mounted curtain air bag module LH/RH
• Occupant classification system (Passenger seat)
• Pop-up roll bar assemblies

Inspect all seat belt assemblies including retractors and attached hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use during a collision should also be replaced if either damage or improper operation was noted. Seat belt pre-tensioners should be replaced even if the seat belts were not in use during a frontal collision in which the air bags were deployed.