OEM Restraints System Part Replacement Search
2024 Volkswagen Taos
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
When working on the Airbag System (pyrotechnic components, Airbag Control Module • J234• , wiring):1) The battery ground cable must be disconnected with the ignition SWITCHED ON. Then cover the negative terminal.
2) Wait for 10 seconds after disconnecting the battery
REV: 06/2024
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
The airbag control module must be replaced[MODULE,AIRBAG CONTROL]:
•If the display “Control module faulty” appears after checking the DTC memory
• after three side/ driver/ front passenger airbag or belt ten-
sioner deployments
• if housing is damaged
• if there is deformation on the tunnel within a 200 mm radius around the control module
Always Replace the Following:
• All deployed airbag units [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG,FRONT SEAT; AIRBAG,ROOF, AIRBAG,KNEE BOLSTER]
• The Battery Interrupt Igniter -N253-
Also with Passenger Airbag Deployment:
• Instrument Panel
• Deformed passenger module supports (cannot be reformed)
• All sensors for front airbag on front end [AIRBAG SENSOR,FRONT]
• Remaining transverse acceleration sensors if the mounting
points are deformed in the sensor area [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
Also with Driver Airbag Deployment:
• Return spring with slip ring [CLOCK SPRING/LVR,STRG]
• All front airbag sensors on the front end [AIRBAG SENSOR,FRONT]
• Remaining transverse acceleration sensors if the mounting points are deformed in the sensor area[AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
Also with Thorax Airbag Deployment:
• Pressure sensors on deployed side
• Transverse acceleration sensors on the deployed side [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
• Cover
• Cushion
• With a folding rear seat backrest: side cushion (if equipped)
• Remaining cross acceleration sensors if anchorage point is deformed in sensor region [AIRBAG SENSOR,FRT DOOR; AIRBAG SENSOR,QTR PANEL]
In Addition:
• All automatic belt retractors with deployed belt tensioners.
• All automatic belt retractors with deployed seat belt force limiters (depending on vehicle equipment)
• Seat belt latches for all automatic belt retractors with deployed seat belt tensioners with the belt on
• Seat belt height adjuster (manual and power) for all automatic belt retractors with deployed seat belt tensioners with the belt on
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
The following components must be checked after every airbag deployment.With a Passenger Airbag Deployment:
• Instrument panel crossmember; front passenger airbag supports and passenger airbag unit must be installed free of tension. Otherwise the crossmember is to be replaced.
• Check the glove compartment for damage. Replace the glove compartment if damaged.
With a Driver Airbag Deployment:
• Steering wheel: Remove the steering wheel and place it with the steering wheel rim on a flat surface. The entire steering wheel rim must rest on the surface. Otherwise the steering wheel should be replaced.
• Check steering wheel for smoke residue. If smoke residue is present, replace steering wheel.
Collision without Airbag Deployment
• If the Airbag Indicator Lamp -K75• does not indicate a malfunction, then it is not necessary to replace the pyrotechnic components. Seat belts must be inspected separately.
After every accident the seat belt system must be inspected systematically
| Additional Information |