OEM Restraints System Part Replacement Search
2023 Mazda MX-30EV
DISABLE PROCEDURE AND TIME (Always Check Service Manual)
1. Switch the ignition to off2. Disconnect the negative battery cable
3. Wait for 1 minute or more to allow the backup power supply of the SAS control module to deplete its stored power
REV: 08/2023
PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT
Deployed airbags: [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL; AIRBAG,FRONT SEAT; AIRBAG,ROOF]Side Air Bag Module Handling:
• After a side air bag has operated (deployed), always replace the side air bag module and the seat back (pad, frame, trim) with new parts.
SAS Control Module Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the SAS control module must be replaced with a new one. [MODULE,AIRBAG CONTROL]
Crash Zone Sensor Handling:
• Once the air bags, pretensioner seat belts and lap pre-tensioner seat belts have operated (deployed) due to a collision or other causes, the crash zone sensor must be replaced with a new one. [AIRBAG SENSOR,FRONT]
Side Air Bag Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the side air bag sensor must be replaced with a new one. [AIRBAG SENSOR,SIDE]
Pressure Sensor Handling:
• Once the air bag has operated (deployed) due to a collision or other causes, the pressure sensor must be replaced with a new one. [AIRBAG SENSOR,FRT DOOR]
Load Limiter Retractor:
• Always replace the seat belt once the load limiter operates.
PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED
Air Bag Module Inspection:• Always use the on-board diagnostic function to diagnose the air bag module for malfunctions
Seatbelt assembles
Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the pre-tensioner seat belt for malfunctions
Lap Pre-tensioner Seat Belt Inspection:
• Always use the on-board diagnostic function to diagnose the lap pre-tensioner seat belt for malfunctions.
If any of the following work is performed, perform the occupant classification sensor calibration using the M-MDS:
• Replacement with a new occupant classification sensor
• Replacement with new passenger-side seat parts
• Disassembly of the passenger-side seat
| Additional Information |